SYLVANIA 72278 Flex Light Remote User Manual
- June 6, 2024
- SYLVANIA
Table of Contents
Remote Instructions
Here are the commands that can be used with the flex light remote:
Troubleshooting remote connection
If for some reason the remote does not connect to the strip’s controller, please re-pair it following these steps:
- Turn off the power for about 5 seconds by switching to “OFF” on the battery box.
- Check the remote battery if it is installed properly.
- Check the battery box batteries if they are installed properly.
- Switch the battery box toggle to “ON” and check to see if it is working.
Warranty
1 YEAR LIMITED WARRANTY: LEDVANCE warrants the Product to be free from defects in materials and workmanship from the date of purchase for the specified warranty period when used as directed. Failure to comply with Product warnings and instructions shall void the warranty. This warranty does not cover Products subject to accident, neglect, abuse, misuse, or acts of God. If the Product fails to operate according to the warranty, return the Product to the place of purchase with proof of purchase date and LEDVANCE will replace it with the same or similar Product free. For additional information, contact 1-800 LIGHTBULB (1-800-544-4828); Email: lightbulb@ledvance.com. THIS IS THE EXCLUSIVE REMEDY AVAILABLE. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED. SOME STATES AND JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR PROVINCE.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications to this device not explicitly approved by the
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Imported by: LEDVANCE LLC
1100 Tyrone Pike Versailles, KY 40383
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>