Zhongshan Xiaolan Qixin Electronics Variable Frequency Fan Lamp Remote Control Instruction Manual
- June 6, 2024
- Zhongshan Xiaolan Qixin Electronics
Table of Contents
Zhongshan Xiaolan Qixin Electronics Variable Frequency Fan Lamp Remote
Control
Buttons
Match coda: After hear the “beep’ sound when tum on the power,at the same time
passcode match/Trun off fan” button for 3 seconds.When remote control sound
twice “beep” then the code has matched
If code doesn’t match successfully, please shut off the power and wait for
about 1 minute, then repeat the last action
Matters needing attention
- Receiver can not be mounted on the plane to avoid affecting the unevenness of the cover and ceiling .
- Receiver sub-inputs and outputs are strict~ prohibited from adjusting input and output pairs.
- The woli<ing voltage of this product AC -265V
- If there is a wall switch on the fan it must be on to control effectively.
- Wiring should be done according to the color of the wire and the instructions on the sleeve.
- When using the remote control please check whether the battery is installed or not Pay attention to the positive and negative poles of the battery. The control key of the handle flashes every key that is pressed
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>