GAZCO 135R eStudio LED Electric Fire Range with Thermostatic Remote Control Instructions

GAZCO 135R eStudio LED Electric Fire Range with Thermostatic Remote

Control Instructions

PAIRING THE REMOTE CONTROL TO THE APPLIANCE

Signal Code
The below operations should be carried out before coding when changing to a new remote or the unit cannot be controlled by the remote:

The reset button is located on the control panel located on the right-hand side.

Press the reset button for 3 seconds (a pen point may be needed) until 3 short beeps sound from the unit, release the button.

Within 10 seconds, press the button on remote. The coding is finished when 1 long beep sounds from the unit.

Resetting of the remote control is necessary if the appliance operates wrongly due to external interference signal and the remote control is not in use.

Open the back cover of the Remote.

Press the Reset button for 3 seconds and reset the coding

ACCESSING THE FUEL BED

GLASS EMBERS

Spread the Glass Embers evenly over the fuel bed.
Note: The Ember Logs (See Log Layout) will rest directly on the fuel bed).

LOG SET – LOG LAYOUT

OPTIONAL SILVER BIRCH SET – LOG LAYOUT

ACCESSING THE FUEL BED

REMOVING THE FUEL BED

REPLACING THE FUEL BED LEDS

REMOVING THE INNER SCREEN

REMOVING THE FLAME EFFECT

REMOVING THE EFFECT SPINDLE

REPLACING THE FLAME EFFECT LEDS

REMOVING THE FLAME EFFECT MOTOR

REMOVING THE RECEIVER

REPLACING THE HEATER

REPLACING THE CONTROL UNIT

PCB

POWER SWITCH

BUTTON BOARD

WIRING DIAGRAM

SPARE PARTS LIST

FOR ENQUIRIES IN THE U.K (EXCLUDING NI):
Gazco Ltd, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG
Tel: (01392) 261900 E-mail: info@gazco.com

FOR ENQUIRIES IN EUROPE (INCLUDING NI):
Stovax Heating Group (NI) Ltd (Comp reg NI675194), 40 Linenhall Street, Belfast, BT2
8BA DX 400 NR Belfast Tel: +44 (0)1392 261990 E-mail: northernireland@gazco.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>