Merchsource 1014884 Portable Electric Key Finder Instructions

Merchsource 1014884 Portable Electric Key Finder

IMPORTANT:
KEEP THIS INSTRUCTION MANUAL FOR REFERENCE Afi IT CONTAINS IMPORTANT SAFETY INFORMATION.

INTRODUCTION

The Portable Electronic Key Finder is a device that makes finding keys simple. The everyday hassle of finding lost keys is eliminated with the touch of a button. You can count on an alarm to direct you to your keys. Whether your keys are lying dose by or up to 45 feet away, the Portable Electronic Key Finder’s wireless transmitter will locate your keys while being carried in- hand with ease. This package includes a remote transmitter, two key ring fobs, and a tabletop cradle for storage.

SAFETY INFORMATION AND WARNINGS

All of the safety and operating instructions should be read, understood and followed before the unit is operated.

PARTS

1. Remote Transmitter
2. Transmitter Cradle
3. K e y Fobs (2)
4. CR2032 Button Cell Batteries (4) {Not pictured)

INSTALLING BATTERIES

REMOTE TRANSMITTER

Requires 2 M A batteries (not included).

1. Grasp the back cover of the transmitter and firmly slide ii down to access the battery compartment i1side.
2. Insert 2 ‘ M A ” 1.5V batteries into the transmitter, aligning the polarity(+/-} of the batteries to match the labels provided inside the battery compartment.
3. Reattach the back cover of the transmitter. Start by positioning the cover on the device with the top edge aligned at the level of the top-most SCffi\,\1$, and then firmly push the entire cover up.

FOBS

Each requires one CR2032 button cen battery (included).
NOTE: There are four CR2032 button cell batteries included. T m must be installed prior to your first use and the other two are replacements. Follow these steps for first-time installation or if the batteries need to be replaced.

1. Grasp the back coter and screw off COL.11terclockwise. See Figure A.
2. Insert a new battery into the metal slot, ensuri1g the”+· side of the battery is facing up. The FOB will make its characteristic beepi7g sound as it is inserted into the slot.
3. Replace the back cover by screwing it clockwise back onto the FOB.
   See Figure B.

NOTE: Be sure tllat the •oPEN• markings are facing the bottom as you screw on the cover. This will ensure that the pieces are property-aligned.

OPERATION

1. Attach the nt.mber-coded fobs to key rings or other appropriate devices to be located.
2. Press the corresponding number-coded button on the Remote Transmitter in order to locate the desired fob
3. lfthe fob is in range (45 feet in an open area), it wia emit an audible beep for a few seconds.
4. If no beep is heard, intermittently press the corresponding button. You may have to change your location if beep is still not heard and continue to intermittently press the corresponding button.
   NOTE: The Remote Transmitter is portable, it can be removed from the provided Tabletop Cradle and carried with you to locate devices attached to a fob.

WARNING

• Do not ingest the battery. Chemical burn hazard.
• (The remote control supplied with) This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns injust2 hours and can lead to death.
• Keep new and used batteries away from children.
• If the battery compartment does not close securely, stop using the product and keep it away from children.
• If you think batteries might have been swallowed or placed inside

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>