tech4home ALALBLE01 Bluetooth Remote Control Instructions
- June 6, 2024
- tech4home
Table of Contents
tech4home ALALBLE01 Bluetooth Remote Control Instructions
Take Off Guide
T4HiU2005/35k
Turn On Alva L1
Alva L1 remote control arrives with a 2 AAA batteries blister inside a
polybag.
To turn on your Alva L1 remote control, please follow the instructions below.
-
Turn ON your TV and your Set Top Box.
-
Remove your Alva L1 remote control and its batteries from the plastic bag.
-
Remove the remote’s battery lid.
-
Place the batteries on the Alva L1 remote control as indicated in the image above and replace the battery lid.
-
After inserting the batteries, wait a few seconds and the Alva L1 remote will be ready to operate the Set-Top-Box.
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or televison
reception, which can be determinated by turning the equipment off an on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement: This equipment complies with FCC portable radiation expuser limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
CAUTION
Risk of explosion if the battery is replaced by an incorrect type, disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion; Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>