tech4home Pali M4 Remote Control User Guide
- June 5, 2024
- tech4home
Table of Contents
Take Off Guide
PALI M4 remote control
Pali M4 Remote Control
Turn On Pali M4
Pali M4 remote control arrives with a 2 AAA battery blister inside a polybag.
To turn on your Pali M4 remote control, please follow the instructions below.
- Turn ON your TV and your Set Top Box.
- Remove your Pali M4 remote control and its batteries from the plastic bag.
- Remove the remote’s battery lid.
- Place the batteries on the Pali M4 remote control as indicated in the image above and replace the battery lid.
- After inserting the batteries, wait a few seconds and the Pali M4 remote will be ready to operate the Set-Top-Box.
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for Class B digital devices, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>