Tech4home NTSSBLE08 Bluetooth Remote Control User Guide
- June 5, 2024
- tech4home
Table of Contents
NTSSBLE08 Bluetooth Remote Control
User Guide
Notus S8 Remote Control
Turn On Notus S8
Notus S8 remote control arrives with a 2 AAA battery blister inside a polybag.
To turn on your Notus S8 remote control, please follow the instructions below.
-
Turn ON your TV and your Set Top Box.
-
Remove your Notus S8 remote control and its batteries from the plastic bag.
-
Remove the remote’s battery lid.
-
Place the batteries on the Notus S8 remote control as indicated in the image above and replace the battery lid.
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for Class B digital devices, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
CAUTION
Risk of explosion if the battery is replaced by an incorrect type, disposal of
a battery into fire or a hot oven, or mechanically crushing or cutting of a
battery, that can result in an explosion; Leaving a battery in an extremely
high temperature surrounding environment that can result in an explosion or
the leakage of flammable liquid or gas;
A battery is subjected to the extremely low air pressure may result in an
explosion or the leakage of flammable liquid or gas.