anko 43072330 2.13M Pre-Lit Snowy Pine Christmas Tree Instruction Manual
- June 6, 2024
- Anko
Table of Contents
2.13M (7ft) PRE-LIT
SNOWY PINE
CHRISTMAS TREE -Tree K
Instruction Manual
includes:
Tree Top (section A)
Upper body (section 13)
Lower body ( section C)
metal stand
43-072-330
How to Assemble:
These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference.
How to assemble:
- Before you start to assemble your tree. place the tree stand on o level surface.
- Read instructions completely before you assemble the tree.
- Insert bottom section C into the stand with screws provided. moke sure it is tightly secured.
- Insert the trunk end of the middle section B into the pole of the bottom section. (Different sizes of the tree may contain several parts of the middle section)
- Insert treetop A into the trunk and make sure the tab fits tightly into the slot in the tree trunk.
- Open all the branches. Shape the branches. start with tips farthest from the pole, one to the right, one to the left, and one at the center of the main stem.
- Wrap the end tip around the wire near the pole.
- After shaping the whole tree following the previous steps step back and take on the overall look of the tree. Shift branches to fill any gap. Slightly upsweep all branch tips for a natural look.
- The tree comes with connector(s) and adaptor(s). (Different styles of the tree may contain several pieces of connector and adaptor). Plug the light set to the connector provided and plug the connector into the adaptor, then plug the adaptor into the power outlet.
- Connect the male and female plug by locating the matching color coding label.
Disassembly and
storage tips:
- Save the carton.
- PulI out the plug from the wall outlet, and remove all ornaments and decorations
- Disassemble the tree by reversing the sequences stated in the assembly instruction. Do not detach factory pre-plugged light sets
- In case of difficulty separating the tree poles (trunk), apply a small amount of lubricant at the joint and rotate the upper pole in both directions. Lift up the upper pole again.
- Press branches against the stem before removing the top to bottom section gently. Carefully replace the tree in its box and tape it shut. Store cartons in a loose and dry place.
- Do not put the tree directly under sunlight or in a clomp area or an area where the temperature exceeds 40 C or 90 F.
- Please save these instructions.
Installation and instructions:
- This tree is suitable for INDOOR USE.
- The adaptor MUST be installed INDOORS away from the weather.
- Do not position or place near heaters or any other direct sources of heat.
- This product is suitable for positioning on surfaces that have normal flammability, e.g. wood, plasterboard, masonry. However, this does not include highly flammable surfaces (e.g. polystyrene. textiles)
- Always position cables and extension leads so that they will not be a hazard to the elderly, pets, and children.
- D0 NOT position this set where it may become covered by other items. e.g. curtains, nets, or bedding
- Ensure the unit (s) are positioned so that you have enough cable to reach an indoor mains power socket.
- The external flexible cable or cord of this luminaire cannot be replaced. If the cord is damaged. the luminaire shall be destroyed.
- Do not connect the tree to the supply while it is in the packaging. Max 3 lighting chain interconnected and max. system wattage is 3.5W after connection.
- For lighting chains intended for interconnection.
-to not interconnect ports of this lighting chain with ports of another manufacturer’s lighting chain
-“Interconnection shall be made only by the use of the supplied connectors. Any open ends must be sealed-off before use”
WARNING:
- Do not try to remove these non-replaceable bulbs.
- This product is NOT designed for permanent or long-term use.
- The supplied adaptor is suitable for the operation of LED Modules only.
- Only operate this light set with the supplied adaptor. Model No. RKPO-AU31001161P44-1
- Do not connect this tree electrically to another tree.
- Do not connect this tree to the power supply while it is in the packaging.
- If any port of light set or cable is damaged, the light set MUST be discarded.
- This product is for use as decoration only. Not to be used by children as a toy. Keep out of reach of children.
- Always switch off this light set or unplug an adaptor if unattended.
- DO NOT overload power sockets or extension leads.
- DO NOT pierce the cable when sourcing in place. bend or stand on the tree. as this will damage the bulbs or wiring.
- Please refer to the packing or product rating label for a product class, specifications, and rating.
LED Bulbs
This light set is constructed with non-replaceable bulbs. DO NOT attempt to
replace any of the bulbs in the light set.
Made in China
12-month warranty
Thank you for your purchase from Kmart.
Kmart Australia Ltd warrants your new product to be free from defects in
materials and workmanship for the period stated above, from the date of
purchase, provided that the product is used in accordance with the
accompanying recommendations or instructions where provided. This warranty is
in addition to your rights under the Australian Consumer Law.
Kmart will provide you with your choice of a refund, repair or exchange (where
possible) for this product if it becomes defective within the warranty period.
Kmart will bear the reasonable expense of claiming the warranty. This warranty
will no longer apply where the defect is a result of alteration, accident,
misuse, abuse, or neglect.
Please retain your receipt as proof of purchase and contact our Customer
Service Centre on 1800 124125 (Australia) or 0800 945 995 (New Zealand) or
alternatively, via Customer Help at kmart.com.au for any difficulties with
your product. Warranty claims and claims for expenses incurred in returning
this product can be addressed to our Customer Service Centre at 690 Springvale
Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure.
For New Zealand customers, this warranty is in addition to statutory rights
observed under New Zealand legislation.
WARNING Do not dispose of the unit in fire or water. > Never attempt to disassemble aid reassemble. Waste electrical products should not be disposed of with household waste. please recycle where toddies exist. I Check with your local authority for recycling advice. > Keep your device and all accessories out of the reach of children and animals. > Small ports may cause choking or serious injury if swallowed. / Avoid exposing your device to very cold or very hot temperatures (below Ot or above 45’C). > Extreme temperatures can cause deforming of the device and reduce the charging capacity and life of your device. > Oo not allow your device to get wet—liquids can cause serious damage. / Do not handle your device with wet hands.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>