clarity 01816 AM-Door Knocker User Manual
- June 6, 2024
- Clarity
Table of Contents
clarity 01816 AM-Door Knocker User Manual
USER MANUAL
Turn O N and turn O F F the device
This device has two ways to turn power on and off. Hardware ON/OFF Slide the
switch to ON or
OFF position. If the slide switch is OFF, you cannot use the software switch
to turn on the power. If the unit is not in use for a long period, use the
hardware switch to turn off the unit.
Hardware switch
Software O N/O F F
This allows the transmitter to be controlled externally. If the sensor is ON,
press and hold the software ON/OFF switch 5 seconds, the LED will flash once,
sensor is “OFF”. If the sensor is
OFF, press and hold the software ON/OFF switch 5 seconds, the LED will flash
three times, sensor is ‘ON’. The sound sensor defaults to “ON” when the
hardware switch is moved from OFF to ON.
Software switch
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the F C C Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenn a .
- Increase the separation between the equipment and receiv e r .
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the F C C rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate this equipment.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
I N C O R R E C T T Y P E D I S P O S E O F U S E D B A T T E R I E S
ACCORDING TO THE INSTRUCTIONS