ANPVIZ SECURITY IPC-D240W-S 3.0-4.0-5.0-8.0MP HD IP POE Dome Camera Instruction Manual
- October 27, 2023
- ANPVIZ SECURITY
Table of Contents
ANPVIZ SECURITY IPC-D240W-S 3.0-4.0-5.0-8.0MP HD IP POE Dome Camera
Package contents
- IP Dome Camera.
- Mounting Kit
- Mounting Template
- Warranty Card
- Per camera in multi-camera packs.
ATTENTION
It is recommended to connect the camera to the NVR or an external PoE switch. If using a DC power adapter (not included) with the camera, a REGULATED power supply is REQUIRED for use with this camera. Use of a non-regulated, non- conforming power supply can damage this product and voids the warranty. If you need a free power adapter, please send mail to: sales@anpvizsecurity.com
Tips on using this Dome Camera
Log We detail her strongly on without w recomthis to use quick mend 11 user you correctly. to reinstruction. ad carefully It will the tell you User marmoreal You also could contact us any time: TechSouport@anpvizsecurity.com
FOR SUPPORT AND INFORMATION, VISIT
- Product Information
- User Manuals
- Quick Start Guides
- support@anpvizsecurity.com
- Specification Sheets
- Software
- Firmware
Also available on the below links
Software Download:
https://www.anpvizsecurity.com/download/hk-series_c003
Scan QR Code to get the documents
Installing the Camera
Before installing the camera:
- Decide whether to run the cables through the OD along the ceiling.
- If you run the cables along the ceiling, you mulll run the cable through the cable notch on the basis will keep the camera base flush to the cei nu when mounted.
To install the camera:
- Use the included mounting template to mark holes forffle the mounting screws.
- Connect the Ethernet cable to the camera as shown in the section ‘Connecting the Camera’.
- If you are running the cables against the ceiling, make sure to pass the cable through the cable notch as shown above.
- Mount the camera to the ceiling using the included mounting screws.
- If you need to adjust the viewing angle of the camera
- Twist the camera left and right to adjust the horizontal position of the camera.
- Loosen the adjustment screw on the side of the camera. Tilt the camera to adjust its vertical position. When finished, tighten the adjustment screw to lock the position.
- Replace the cover and tighten the cover screws.
- Remove the protective film from the dome cover.
Connecting The Camera
Camera
Connect the Ethernet cable to the camera
NOTES:
- For weatherproofing instructions, see filing the Ri45 Cable Gland {Optional).A 12V DC power adapter
- {not included) is only required if connecting the camera s Ethernet cable to a router or Switch that does not support POE.
NVR
Connect the other end of the Ethernet cable to the NVR”S POE ports. The camera
may take a minute to power up after being connected.
Connect the other end of the Ethernet cable to a router or switch on your network. See your NVR manual for details on connecting the camera to your NVR using a switch or router
Accessing via Web Browser or Mobile
Tips
- Modify the IP address of the camera by SADP in the same subnet of your computer firstly.
- Make sure the camera is powered on.
Need Help?
Visit us online for up-to-date software and complete instruction manuals
support@anpvizsecurity.com
Firmware Download:https://www.facebook.com/groups/532338207739441
Scan QR code adding to Anpviz Facebook group www.anpvizsecurity.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>