EUREKA FORBES NRICH UV Water Purifier User Manual

EUREKA FORBES NRICH UV Water Purifier

The Power of AQUAGUARD

Aquaguard Select NRICH removes all the harmful substances from water and retains the good minerals. But what’s really different about this purifier is its Active Copper Maxx™ technology that adds Calcium, Magnesium, Copper and Zinc to your drinking water.Aquaguard® Select NRICH ensures that you get your dose of minerals from water.
It comes with a special HD RO/HD GREEN RO membrane that purifies water and the advanced Mineral Guard”‘ technology, that retains essential natural minerals in water that other water purifiers deplete.
Dust free Bacteriostatic Activated Carbon removes excess chlorine and organic impurities while retaining essential minerals.
The Aquaguard® Select NRICH 100%RO+100% UV comes with advanced UV LED technology, that ensures the purified water to be always safe.

Installing Your Aquaguard® Select

Make sure that your Aquaguard® Select NRICH is installed by a trained Eureka Forbes Service Technician only.

1. Input water must be tested for Total Dissolved Solids (TDS).
2. Install your Aquaguard® Select NRICH in a dry, ventilated place. Keep it away from direct sunlight, heating devices or areas below freezing temperatures. You can keep it on the kitchen counter or wall mount it.
3. Ensure that the input tap water temperature is in the range of 10°C-40°C. Do not install to a hot water tap as it can damage the filters.
4. Make sure that the tap water pressure is not exceeding 3.0 kg/cm2 for NRICH 100%R0+100%UV/HD RO/HD GREEN RO and between 0.3 and 2.0 kg/cm2 for NRICH HD UV.
5. After installing, run the purifier for 5-10 mins.
6. Make sure that the reject water pipe (Blue colour pipe available in Aquaguard® Select NRICH HD RO/HD GREEN RO/100%RO+100%UV models only} is placed lower than the purifier, to avoid stagnation of high TDS reject water in the pipe.

Input Water Quality Usage Limitations:

1. If the input water iron content is more than 0.3 mg/litres; use of an iron remover* is recommended as a pre-treatment.
2. If the input water turbidity is more than 5 NTU or comprises colloidal particles, use of a special filter is required as a pre-filter.
3. If the input water TDS is more than 1,000 ppm (mg/L) or input water hardness is more than 300 ppm (mg/L), use of a Membrane life enhancer** is recommended.
4. Do not install the water purifier if the TDS is more than that prescribed in the Technical Specifications.
   **Available at an extra cost.

Aquaguard® Select AQUAGUARD® SELECT NRICH HD UV WORKS

PURIFICATION PROCESS

FOR AQUAGUARD® SELECT NRICHHOUV

TECHNICAL SPECIFICATIONS*

Standard TastCondNions:
Feed Waler Quality: TDS Max: 200 mg/litres,
Pressure: 1.0 kg/cm’, Turbidity: Max.1 NTU, Temperalure: 25• C, Chlorine: below0.2 mg/lilres, Iron: below0.3 mg/litres Life:6,000″lilres.
‘Actual performance may vary based on the input water Conditions: Turbidity and Pressure.

FOR AQUAGUARD® SELECT NRICH HD RO/HD GREEN RO

***Not a part of the product, a Membrane life enhancer is recommended. If the input water TDS is more than 1,000 ppm (mg/L) or input water hardness is more than 300 ppm (mg/L). Available at extra cost.

TECHNICAL SPECIFICATIONS

HERE’S HOW YOUR AQUAGUARD® SELECT NRICH 100%RO+100%UVWORKS

PURIFICATION PROCESS

FOR AQUAGUARD® SELECT NRICH 100%RO+100%UV

***Not a part of the product, a Membrane life enhancer is recommended. If the input water TDS is more than 1,000 ppm (mg/L) or input water hardness is more than 300 ppm (mg/L). Available at extra cost.

TECHNICAL SPECIFICATIONS

KNOW YOUR AQUAGUARD SELECT NRICH NEXT-GEN LED DISPLAY

CLEANING AND DISINFECTION OF WATER STORAGE TANK

Note: Storage Tank of this product must be periodically (at least once every 30 days) cleaned by a disinfectant. Disinfection Tablets may be purchased from the Company authorized Service Centre. Please follow the disinfection process strictly as per the instructions provided in this User Manual.

• Switch OFF the water puffier from the main power supply.
• Open the top cover and push the tap lever UP, to drain the tank.
• Wipe the inside of the tank with a dry, clean soft cloth.
• Keep the top cover in place.
• Switch the power supply ON.
• Let the storage tank get filled & then drop one disinfection tabler into the tank.
• Keep the top cover in place & leave the unitfor30 min.
• After 30 min. open the tap &discard this and the first filling water completely. Caution: Do not drink this water
• Now your unit is ready to use.
• Please ensure that this disinfection process is carried out by the authorized installation person/service technician during the first installation and in every subsequent mandatory servicing of your product.

Available with Eureka Forbes Service Technician.

MAINTAINING

• Fill the tank and disinfect the storage tank with a disinfection tablet.
• Discard the first filling of the water from the storage tank.
• Drain the water from the tank ~it hasn’t been used for over 48 hrs.
• Ensure that the flow restrictor is checked and replaced {if required) by the authorized service technician during the mandatory service or in-service call.
• Ensure that the replacement of the consumable cartridge is done by the trained Eureka Forbes Service Technician after approximately 6,000 liters of water usage or when chocked.

FOR AQUAGUARD® SELECT NRICH HD UV/100%RO+100%UV

IMPORTANT NOTE ON ZERO PRESSURE PUMP

Your Aquaguard® is equipped with a unique pump having both suction and boosting capabilities with specially designed ZPP and DRS (Dry Run Sensor) Claims. Now, this enables your Aquaguard® to work in the following operating conditions:-

• Normal Input Water Pressure – up to 3 bar (max.)
• Low Water Pressure from Loft Tank
• Zero Water Pressure
• Suction Mode – Maximum 1m below product level

Product Functioning with ‘Normal/Low & Zero Pressure’:

• Ensure that the water flow from the tap into the product is always more than 1.5 LPM.
• In case there is no incoming water supply, the DRS detects unavailability of water and stop the unit from working to prevent dry running.
• As and when the water supply resumes, the DRS detects the availability of water and restarts the product. Meanwhile, the intelligent mechanism in your Aquaguard will keep on checking the availability of water at regular defined intervals and make the product work as and when water supply resumes.
  Note: In case you notice that water in the supply line resumes and product is in stand-by mode, then please restart the product by switching OFF and ON the power supply.

Product Functioning with ‘Suction Capability’:

• Whenever the water in the container/ bucket gets over and bucket gets empty, the DRS detects non water availability and stops the product from functioning. Note: When the water is refilled in the container/ bucket, the product should be restarted by switching Off and On the power supply.
• Prolonged use in loft tank mode/suction mode can impact the working of pump, performance of product and life of filters. if the performance is not meeting the expectation of the consumer due to low pressure, then use of a booster pump is recommended.
• Do not re-circulate/reuse the rejected water (discharged by the product) back into the product.
• The booster pump in your Aquaguard® also has the capability of suction of water from a 1 m distance below the level of product i.e. it can pull water from a bucket/container.
  Note: It is not suitable for suction of water from underground storage tank, sump, open well etc. where the water level is beyond 3 feet below the level of product.

WARRANTY TERMS & CONDITIONS

1. The Products are warranted against manufacturing defects for a period of twelve (12) months from the date of original purchase.

2. The Customer will notify the Company in writing promptly of any defects noticed and give the Company or its authorized agent adequate opportunity to inspect test and remedy them for which the Customer will deposit the goods at its own expense, if so, required by the Company with the Company’s Office/Service Centre along with the original invoice in the city where they are sold.

3. The Inspection and Test Report of the company’s office/service centre will be final and binding under the warranty for determining defects, repairs / alterations required or carried out or certifying work of the goods thereafter.

4. Aquaguard® may require initial setting, post-installation, depending on varying water conditions and power supply. In case of any service requirement, post-installation, please contact the company’s service centre.

5. The company or its authorized agent will be entitled to retain any defective part replaced under the warranty.

6. Notwithstanding anything to the contrary contained or implied by this warranty:

7. The company’s liability under this warranty shall be limited to the first sale of the goods by the company to the customer and will not apply or extend
   to any secondary sale of goods by the customer.

8. The company’s liability under this warranty shall be limited only to defects in the goods which occur under the conditions of normal operation of the goods and their proper and prescribed use. The warranty does not cover or extend to defects which are determined by the company or its authorized agents as occurring or resulting from or attributable to negligence, abuse, misuse, faulty care, operation or maintenance or repairs, alterations to the goods or any part thereof by others or the use of the goods on electrical supply for which they are not designed, or damage caused by lightening or other electrical disturbances or interruptions, dismantling or re-installation at a different location.

9. The company’s liability under this warranty shall remain valid only if the goods are duly installed by the company or its authorized agency at the location specified in the invoice and such installation is undertaken by the company or its authorized agent or franchisee.

10. Consumable items mentioned in the consumables table are subject to normal wear and tear are not covered by this warranty. Please refer model specific components given in the user manual under the table “consumable cartridges”.

11. Reverse Osmosis Membrane warranty is for a period of 1 year (or) 6,000 litres (whichever is earlier) from the date of installation, on the condition that the input water is as per the standard test conditions for RO variants (provided in the section “Technical specifications table”), mentioned in the user manual. If the RO membrane gets clogged within warranty period, it will be cleaned/repaired/replaced free of charge as deemed fit by the company authorized service person/centre after inspection. (At applicable for RO models only.)

12. The customer will have no claim against the company, its employees and its authorized agents or franchisees under or pursuant to this warranty in respect of death or injury to the customer or any other person or loss or damage to any property caused by or due to equipment failure, breakdown or accident, fire or operation or utilization of the goods otherwise than in accordance with the user manual or by due to any other cause or circum stances beyond the control of the company.

13. The company’s liability, under this warranty, shall in no event and under no circumstances exceed the price paid by the customer to the company for the goods stated in the invoice.

General

For the purpose of this warranty, the following expressions shall have the following meanings respectively:

1. The ‘Goods’ shall mean the goods described in the Order Form.
2. The ‘Customer’ shall mean the original purchaser of goods from the company.
3. The ‘Company’ shall mean EUREKA FORBES LIMITED.
4. Aquaguard® means and includes Aquaguard®, Aquaguard® Select and Sure from Aquaguard®.
5. ‘General Terms & Conditions’ shall mean the terms and conditions agreed upon by the customer and the company printed on the Order Form.
6. ‘Invoice’ shall mean the invoice issued by the company to the customer describing the goods and indicating, inter alia, the total purchase price thereof and name of the customer.
7. ‘User Manual shall mean the instructions for installation, use and maintenance provided through QR code along with Product supplied by the company.
8. EFL reserves the right, in its absolute discretion, to change, alter or discontinue and alter the terms and conditions from time to time without any prior notice.
9. Any disputes are subject to Mumbai Jurisdiction only. Post-warranty
10. The customer may be offered a yearly Service Contract at the prevailing company rates and terms.
11. In case the customer does not wish to enter the Service Contract, he has the option of calling the company’s service centre having his Aquaguard® services on an actual basis, i.e., by paying the labour cost and spares needed to attend to that service/complaint call at the prevailing company rates. Such service will be rendered by the company in towns/places where the company has its service centres.
12. If during such servicing it is necessary for the company to replace or repair defective components or parts, the customer shall be required to pay for the same as per the company’s prevailing price list.
13. Eureka Forbes limited reserves the right to offer annual maintenance contract/ensure availability of spares only up to 7 years from the date of invoice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>