EXPLORE SCIENTIFIC ST1004H Wireless Temperature and Humidity Sensor with LED Instruction Manual
- June 6, 2024
- EXPLORE SCIENTIFIC
Table of Contents
- GENERAL WARNINGS
- SCOPE OF DELIVERY
- BEFORE YOU BEGIN
- **PRODUCT OVERVIEW
- GETTING STARTED
- SPECIFICATIONS
- EC DECLARATION OF CONFORMITY
- RCM DECLARATION OF CONFORMITY
- NOTES ON CLEANING
- FCC compliance statement:
- DISPOSAL
- WARRANTY & SERVICE
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Art.No.: ST1004H
WIRELESS TEMPERATURE & HUMIDITY SENSOR WITH LED
INSTRUCTION MANUAL
GENERAL WARNINGS
- Risk of electric shock — This device contains electronic components. Only use the device as described in the manual; otherwise, you run the risk of an electric shock.
- Choking hazard — Children should only use the device under adult supervision. Keep packaging material, like plastic bags and rubber bands, out of the reach of children, as these materials pose a choking hazard.
- Risk of chemical burn – Keep batteries out of the -reach of children! Make sure you insert the batteries correctly. Leaking battery acid can lead to chemical burns. Avoid contact of battery acid with skin, eyes, and mucous membranes. In the event of contact, rinse the affected region immediately with plenty of water and seek medical attention.
- Risk of fire/explosion — Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into Excessive heat or improper handling could trigger a short-circuit, a fire, or an explosion.
- Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if
- Use only the recommended batteries. Always replace weak or empty batteries with a new, complete set of batteries at full capacity. Do not use batteries from different brands or with different capacities. The batteries should be removed from the unit if it has not been used for a long time.
SCOPE OF DELIVERY
Outdoor sensor, Operating instructions.
BEFORE YOU BEGIN
- We recommend using alkaline batteries. If temperatures regularly fall below 0°C (32°F), we recommend using lithium batteries.
- Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power requirements.)
- Insert batteries before first use, matching the polarity in the battery compartment. 2x AAA Batteries are required for the outdoor sensor.
**PRODUCT OVERVIEW
**
OUTDOOR SENSOR
- Battery compartment door.
- Battery compartment.
- RESET button (reset all settings).
- Channel switch.
- Data transmission light
GETTING STARTED
The main unit can receive data from up to 3 outdoor sensors.
- Remove the battery door from the back.
- Select a channel.
- Insert 2x AAA (LR03)/1.5V batteries. Please ensure the polarities (+/-) of the batteries match upon installation.
- Reattach the battery door.
- Place the sensor within 30 m (98 ft) of the main unit using the table stand or wall mount.
- Initiate a sensor search on the main unit to start receiving temperature data from the sensor.
NOTE: Replace batteries when displayed on the main unit or when the display is dim.
Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than1.5m (5ft) and which can shield it from direct sunlight or wet conditions for an accurate reading.
The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results.
SPECIFICATIONS
Dimensions: 50 x 25 x 95 mm (L x W x H)
Weight: 45 g (Exclude batteries)
Transmission range: 30 m (98 ft)
Temperature range: -40°C to 70°C (-40°F to 158°F)
Humidity range: 20 – 95% RH
Signal frequency: 433 MHz
Maximum transmission power: under 10mW
Power: 2x AAA (LR03) 1.5V batteries
EC DECLARATION OF CONFORMITY
Hereby, Explore Scientific GmbH declares that the equipment type with part number: ST1004H is in compliance with Directive: 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.bresser.de/download/ ST1004H/CE/ST1004H_CE.pdf
RCM DECLARATION OF CONFORMITY
The product complies with electrical safety, EMC, and radio spectrum regulatory requirements for products supplied to the Australian or New Zealand market.
NOTES ON CLEANING
- Remove the batteries before cleaning.
- Only use a dry cloth to clean the exterior To avoid damaging the electronics, do not use any cleaning fluid.
- Protect the device from dust and moisture.
FCC compliance statement:
This device complies with Part 15 of the FCC Rules. Operation Is subject to
the following two conditions: (1) this device may not cause harmful interfere
nce, and (2) this device must accept any interference received, including
interference that may cause undesired operation. changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.lf this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
DISPOSAL
Dispose of the packaging materials properly, according to their types, such as paper or cardboard. Contact your local waste disposal service or environmental authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage!
As per the Directive 2002/96/EC of the European Parliament on waste electrical
and electronic equipment and its adaptation into German law, used electronic
devices must be collected separately and recycled in an environmentally
friendly manner.
In accordance with the regulations concerning batteries and rechargeable batteries, disposing of them in normal household waste is explicitly forbidden. Please make sure to dispose of your used batteries as required by law — at a local collection point or in the retail market. Disposal in domestic waste violates the Battery Directive. Batteries that contain toxins are marked with a sign and a chemical symbol.
- battery contains cadmium
- battery contains mercury
- battery contains lead
WARRANTY & SERVICE
The regular guarantee period is 5 years and begins on the day of purchase. You can consult the full guarantee terms as well as information on extending the guarantee period and details of our services at www.bresser.de/warranty_terms.
MANUAL DOWNLOAD:
EU: www.bresser.de/download/ST1004H
USA: www.explorescientific.com/weather-clock-
manuals
SERVICE AND WARRANTY:
EU: www.bresser.de/warranty_terms
USA:
www.explorescientific.com/warranty
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>