HYTRONIK HED6010 10W Dali 2 LED Driver Instruction Manual
- June 6, 2024
- HYTRONIK
Table of Contents
INSTRUCTION MANUAL FOR 10W DALI LED DRIVER
MODEL NO.: HED6010
LED CURRENT SELECTION
The current can be easily configured by choosing the correct combination of the DIP switches (see table below):
WIRING DIAGRAM
WARNING: Please make sure the correct current is selected before starting the driver!
Highlights
- In compliance with DALI 2 standard
- DALI default feedback
- DALI, switch-Dim dimmable
Switch-Dim
-
On/off control: short push (<0.5s) on the switch.
Note: Short push should be at least 0.12s, and the time interval between two pushes should be also longer than 0.12s. -
Stepless dimming: long push (>0.5s) on the switch.
-
For fine-tuning of light level: With every other long push, the light level goes in the opposite direction.
-
Built-in with permanent memory: light returns to the previous dimming level when switched off and on again, even at power failure.
Synchronization
Up to 64pcs drivers can be connected to the same switch, thanks to the
program. This means there is no need for any additional synchrony wire in
large installation, where many drivers should be controlled by one switch.
Please follow the step below to achieve synchronization function if more than
one driver is connected to the same push button:
- Do a long push for more than 15s, then the system is synchronized and all lights in the group dim down to 50%.
Permanent Memory
This driver has built-in permanent memory against power failure, which means
the light always starts up at the previous level when it was switched off last
time.
SPECIFICATION
| Mains voltage | 220 -240VAC 50/60Hz |
|---|---|
| Mains current | 71 – 65mA |
| Max. output power/current/voltage | 1.5-8W/195mA/6-41V 1.5-9W/230mA/6-41V |
1.5-10W/250mA/6-41V 2-12W/300mA/6-41V
2.5-12.8W/350mA/6-36V 2.5-12.8W/400mA/6-32V 3-12.5W/500mA/6-25V
Power factor| 0.90
Operation temperature| Ta: -20-4-50 ‘C Tc:+75-C
Max. Efficiency| 88%
Dimming interface| DALI, Switch-Dim.
Abnormal protection| Output short-circuit protection, Overload Protection,
Open-circuit Protection with auto-reset
EMC standard| EN55015, EN61547, EN61000-3-2/-3-3
Safety standard| EN61347-1, EN61347-2-13
DALI standard| IEC62386-102,207
Dielectric strength| Input. output: 3000VAC
Certification| CE, CE, EMC
IP grade| IP20
SENSOR & LIGHTING CONTROL
HYTRONIK INDUSTRIAL LIMITED
Room D, 10/f, Tower A, Billion Center, 1 wang Kwong Road,
Kowloon Bay, Kowloon, Hongkong
T: 00852-35197525 F: 00852-30116936
E: info@hytronik.com
CHINA FACTORY
3rd Floor, Block C, complex building, 155#, Bai’gang road south,
Bai’gang village, Xiao Jin Kou Town, Huicheng District, Huizhou 516023
Tel:86-752-2772020
F:86-752-2777877
E: info@hytronik.com
W: www.hytronik.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>