soundmaster UR230WE Radio Alarm Clock FM Mood Lighting Instruction Manual

: June 6, 2024
: soundmaster

Table of Contents

LOCATION OF CONTROLS
INSTALLATION
CLOCK SETTING
RADIO
NATURAL SOUND
ALARM
SLEEP
DISPLAY / MOOD LIGHT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

soundmaster UR230WE Radio Alarm Clock FM Mood Lighting Instruction Manual

ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual or packaging The materials are reusable according to their markings. By reusing, recycling or other forms of utilization of old devices you make an important contribution to the protection of our environment. Please contact your local authorities for details about collection points.

This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.

This symbol indicates the presence of important operating and maintenance instructions for the device

Used batteries are hazardous waste and NOT to be disposed of with the household waste! As a
consumer you are legally obligated to return all batteries for environmentally responsible recycling no matter whether or not the batteries contain harmful substances) Return batteries free of charge to public collection points in your community or shops selling batteries of the respective kind. Only return fully discharged batteries ) marked Cd = cadmium, Hg = mercury, Pb = lead

Only use mercury and cadmium-free batteries.
Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
Keep batteries away from children. Children might swallow batteries.
Contact a physician immediately if a battery was swallowed.
Check your batteries regularly to avoid battery leakage.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type

WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.

Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product
and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

Safety, Environmental and Setup Instructions

Use the device in dry indoor environments only.
Protect the device from humidity.
This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries.
No objects filled with liquids, such as vases, shall be placed on the apparatus.
The mains plug or an appliance coupler is used as the disconnect device, the disconnect devices shall remain readily operable.
Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.
Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
A damaged mains cable or plug must immediately be replaced by an authorized service center.
In case of lightning, immediately disconnect the device from the mains supply.
Children should be supervised by parents when using the device.
Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
Do not expose the device to direct sunlight or other heat sources.
Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
Do not cover the ventilation openings!
Install the device at a safe and vibration-free location.
Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.
Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.
No naked flame sources, such as lighted candles, should be placed on the unit.
When you are necessary to ship the unit store it in its original package. Save the package for this purpose.
In case of malfunction due to electrostatic discharge or fast transient (burst), remove and reconnect the power supply.
If the unit is not using for a long period of time, disconnect it from the power supply by unplugging the power plug. This is to avoid the risk of fire.

LOCATION OF CONTROLS

MEM/M+ / SET / Y-M-D button
MOOD LIGHT button / MOOD LIGHT CHANGE button
LIGHT UP button
LIGHT ON/OFF button / SNOOZE button
DIM DOWN button
ALARM 2 button / VOL UP button
POWER button / SOURCE button / ALARM OFF button
ALARM 1 button / VOL DOWN button
DOWN button
UP button
SLEEP button / DIMMER button
Battery Compartment
Lamp shade
Alarm 1 indicator
Display
FM indicator
Alarm 2 indicator
DC IN jack
USB jack (only for charging)
Antenna

INSTALLATION

Use only the supplied power adapter! The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

Ensure that the voltage is the same as that indicated on the power adapter identification plate.

Connect the cord of the power adapter to the DC IN jack of the radio.
Connect the plug of the power adapter to a wall socket.
The radio is powered and in standby mode when you see the display is switched on.

Backup system

➢ The radio is equipped with a backup system. It requires a 3 V lithium battery (type: CR2032). Insert the battery into the battery compartment and make sure the positive and negative (+ or -) sides of the battery are in contact with the corresponding terminals in the battery compartment.
➢ If a power cut occurs, the radio automatically switches to the battery power supply and keeps the clock and timer settings.
➢ To open the battery compartment, use a screwdriver to detach the screw on the compartment door.
➢ When replacing the battery, do not disconnect the power adapter. Otherwise, all clock and alarm settings will be lost.
➢ In Backup system the display doesn´t show anything. The display is dark.

CLOCK SETTING

Make sure that the unit is in Standby. If the radio is playing any music source (i.e. radio or nature sound), press the POWER button to switch it OFF.
Press and hold the SET button to enter the clock setting mode.
Press the SET button repeatedly to cycle through the setting options:
The display sequence in calendar / time set mode will be as follows:

Year → Month → Date → 12/24 Hour Time Format → Real Time Hour → Real Time Min → Normal Time

➢ Press the DOWN or UP button to adjust the values in each setting option. Press and hold the button to change the values quickly.
➢ Press the SET button to confirm each setting option.

RADIO

Listening to radio
Unroll and extend the antenna to improve FM signal reception.

Press the POWER button to switch the music mode on.
Press and hold the SOURCE button to select the music mode: FM or natural sound (radio frequency shows on the display for FM).
Press the DOWN or UP button to adjust frequency.
Press and hold the DOWN or UP button to automatically tune to the next available FM station.
Press the POWER button to switch the radio mode off.

Setting preset stations
You can store up to 10 preset stations.

Tune to the desired station.
Press and hold the MEM/M+ button until “P01” (or the next available preset slot) shows on the display.
Press the DOWN or UP button to select a preset number (P01-P10).
Press the SET button to confirm. The preset station has been set up.
Press the MEM/M+ button repeatedly while listening to the radio to select a preset station. Alternatively, press the MEM/M+ button once and then press the DOWN or UP button to select a preset station.

NATURAL SOUND

Six nature sounds are available to enhance ambience.

Press the POWER button to switch the music mode on.
Press and hold the SOURCE button to select the nature sound mode (n-1, n-2, n-3, n-4, n- 5, n-6 shows on the display).
Press the DOWN or UP button to select a nature sound.
Press the POWER button to switch the nature sound mode off.

ALARM

Setting of the alarm time
The radio lets you have 2 alarm settings. To set the alarms:

Make sure that the device is in Standby. If the radio is playing any music source (i.e. radio or nature sound), press the POWER button to switch it OFF.
Press the ALARM 1 or ALARM 2 button to show the current alarm 1 or 2 setting, respectively.
Press and hold the ALARM 1 or ALARM 2 button to enter the alarm time setting mode.
In the alarm setting mode, press the ALARM 1 or ALARM 2 repeatedly to cycle through the setting options:
Alarm hour time → alarm minute time → Alarm frequency (see note 1) → Alarm sound source (see note 2) → Light intensity

Note:

In the alarm frequency setting, you can select the following options:
1-5 = Monday to Friday,
1-7 = Everyday,
6-7 = Weekend only,
On one selected day once a week only: 1=Monday, 2=Tuesday, 3=Wednesday, 4=Thursday, 5=Friday, 6=Saturday or 7=Sunday
Select the alarm sound:
➢ buzzer (“bu” shows on the display)
➢ radio (the last played radio frequency shows on the display) ➢ nature sound (“nS” shows on the display)
All alarm sound sources will increase their volume gradually when the alarm sounds.

If the radio is selected as the alarm sound source, you are prompted to select the radio maximum volume when the alarm sounds. If the nature sound is selected as the alarm sound source, you are prompted to select the type of nature sound (n-1, n-2, n-3, n-4, n-5, n-6) and then the maximum volume when the alarm sounds.

Alarm wake-up light
➢ The wake-up light can be set at a light intensity level from L01 to L20 or off. If a light intensity level from L01 to L20 is set, the light will switch on at its lowest intensity 30 minutes before the set alarm time.
➢ The light will then gradually increase to the set maximum brightness until the alarm goes off. For example, if the alarm is set for 8:30 with a light intensity of L10, the light will switch on at 8:00 at the lowest level (L01) and gradually increase to the light level L10 at 8:30.
➢ The light will not turn on if the alarm is set less than 30 minutes before the set time.

Turning the alarms on or off
When the clock time is displayed, press and hold the ALARM 1 or ALARM 2 button to enable or disable the respective alarm. The corresponding alarm icon (AL1 or AL2) will switch on when the alarm is enabled.

Deactivating a sounding alarm
➢ Press the LIGHT ON/OFF button to temporarily silence the alarm (snooze) and then press the ALARM OFF button to switch off a sounding alarm.
➢ When the alarm sounds, the corresponding alarm icon (AL1 or AL2) flashes on the display. The alarm will continue sounding for 60 minutes if no button is pressed. Then it will stop automatically until the same time next day.
Snooze To temporarily silence a sounding alarm, press the

SNOOZE
➢ To temporarily silence a sounding alarm, press the SNOOZE button. The alarm will sound again when the snooze period (9 minutes) is over.
➢ The corresponding alarm icon (AL1 or AL2) flashes on the display during the snooze period.
➢ To cancel the snooze period and the alarm, press the ALARM OFF button for the corresponding alarm.

SLEEP

➢ This sleep function defines the duration of time before the radio switches itself off automatically.
➢ When the radio is switched on, press the SLEEP button repeatedly to select a sleep period (Options: Off, 15, 30, 60, 90 and 120 minutes).
➢ The radio will automatically switch off when the sleep period is over.
➢ Press the SLEEP button to check the remaining time before the radio switches off.
➢ Press the POWER button to cancel this function.

DISPLAY / MOOD LIGHT

Display information

Press the POWER button to switch off any music source.
Press the Y-M-D button repeatedly to change showing the week, year, date and clock time.

Display brightness
In standby mode, press the DIMMER button to change the brightness level of the display (low, medium or high).

Reading light
➢ Press the LIGHT ON/OFF button to switch on or off the reading light.
➢ Press the DIM DOWN or LIGHT UP button to reduce or increase the brightness.

Mood light
➢ Press the MOOD LIGHT button to turn on or off the mood light. The light will alternate in different colors.
➢ Press and hold the MOOD LIGHT CHANGE button to stop the light from alternating in colors. Repeat this step to cancel this function.

Copyright by Woerlein GmbH, 90556 Cadolzburg, www.soundmaster.de

www.soundmaster.de

Wörlein GmbH
Gewerbestraße 12
D 90556 Cadolzburg, Germany
Tel: +49 9103 71 67 0
Fax: +49 9103 71 67 12
E-Mail: info@soundmaster.de
Internet: www.soundmaster.de

Hereby, Wörlein GmbH declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the declaration of conformity can be obtained from the above address