HOTONE MIDI Foot Controller Pedal Bluetooth Ampero Control 4 Button Instructions
- June 6, 2024
- HOTONE
Table of Contents
Screen Display
| Bluetooth | MIDI | Bank |
|---|---|---|
| Bluetooth not connected |
This indicates a
PC message (PC 16) has been sent
| This indicates unit bank change
(bank 00 to bank 01)
Bluetooth connected| This indicates a CC message (CC 112)
has been sent
The Bluetooth indicator (the dot shown above) will flash when Amparo Control is in Bluetooth Pair Mode (hold FS 2+3).
Getting Started
- Turn on the Bluetooth switch on your mobile device, then turn on your Amparo Control and launch the app.
- Login to your account (optional).
- Press and hold FS 2+3 on your Amparo Control to enable Bluetooth Pair Mode. A dot will flash on the bottom right corner of the screen of your unit to indicate pairing status.
- When your Ampero Control appears listed on the startup page, select and tap the “Connect To The Selected Device” button on the screen. If the search failed, you can retry searching by manually tapping the “Search Again” button.
Notes:
- You can enter offline mode if no device is found.
- Ampero Control can only be edited by one device at a time. To use other devices, tap the “Settings” icon on the lower right corner of the screen, find “Connection Status” and enter, then tap “Disconnect”. Connect another device when finished.
- The default device name is Ampero Control. You can customize your device name if needed.
Thank you for purchasing a Hotone product. Scan the QR code for the full
manual and app download links.
www.hotoneaudio.com/support
We recommend you update the latest firmware/software for the best possible experience.
FCC regulation warning (for USA)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna transmitter. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
FCC ID:2AHJSEC-4
*157g
273124mm
**www.hotoneaudio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>