Remote Pro RIB Sun Coding Gate Motor Instructions
- June 6, 2024
- Remote Pro
Table of Contents
RIB SUN CODING INSTRUCTIONS
- Remove the cover of your gate motor.
- On the gate, the motor move DIP 1 left to ON position (figure 1) and then DIP 3 left to ON position (figure 2). The programming two-color led DL10 flashes green for 10 seconds.
- In less than 10 seconds on the new remote press the button you would like to code to the motor. If the remote control has been saved correctly, two-tone led DL1 (figure 3) turns red for an instant, and a buzzer tone confirms the saved entry. If you are coding more than one remote, the 10 seconds for programming the codes are reset automatically with two-tone led DL10 that flashes green to save the next remote control.
- To finish programming, wait 10-15 seconds and the motor will exit learn mode. The motor has exited learn mode when the programming led DL10 stops flashing.
- Switch DIP 1 to the right (of) and DIP 3 to the right (OFF).
- Test all remotes to ensure they operate the gate.
WARNING
To prevent possible SERIOUS INJURY or DEATH:
– Battery is hazardous: NEVER allow children near batteries.
– If the battery is swallowed, immediately notify a doctor. To reduce risk of
fire, explosion, or chemical burn:
– Replace ONLY with the same size and type battery
– DO NOT recharge, disassemble, heat above 100° C, or incinerate Battery will
cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed
inside any part of the body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>