Remote Pro RPR100-C-002 CSI Classic CSI-1 Upgrade Receiver Kit Installation Guide
- June 6, 2024
- Remote Pro
Table of Contents
Installing Receiver to CSI Classic CSI-1 Motor
- TURN OFF THE POWER OF THE MOTOR FROM THE POWERPOINT
- View the diagram below and ensure that it matches the back of your motor.
- Connect the black receiver cable to the PB.
- Connect the blue receiver cable to GND.
- Connect the brown receiver cable to 24V.
- Turn the power back on and ensure the receiver powers up.
- Your two new remotes have been pre-programmed to the receiver.
Press button 1 on your new remote to ensure it can operate the door.
Coding new remotes
Please Note: Your original remotes will continue to work
- Press the black learn button inside the receiver located next to the LED light until the LED illuminates.
- Press and hold any button on your new remote until the LED flashes 3 times.
- The remote is now coded, please test the remote to ensure it can operate the motor.
- If you have more than one new remote, please repeat steps 1-3.
www.remotepro.com.au
WARNING
To prevent possible SERIOUS INJURY or DEATH:
- The battery is hazardous: NEVER allow children near batteries.
- If the battery is swallowed, immediately notify a doctor.
To reduce the risk of fire, explosion, or chemical burn:
- Replace ONLY with the same size and type of battery
- DO NOT recharge, disassemble, heat above 100° C, or incinerate
The battery will cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed inside any part of the body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>