INVENTUM GF461 Cold Zone Fryer Instruction Manual
- June 6, 2024
- INVENTUM
Table of Contents
Koude zone friteuse
GF461
Instruction manual
Safety instructions
-
Please read these instructions before operating the appliance and retain for future use.
-
Attention: The capacity of this double fryer is 2 x 1800 Watts. Therefore check the maximum of your electric circuit before you plug in both fryers.
-
The appliance is intended solely for domestic use within the home.
Attention! Avoid touching hot surfaces, especially the outside of the appliance when the appliance is in use. -
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.
-
Never let the power cord of the appliance hang over the edge of a table or counter, touch hot surfaces or become knotted.
-
Never place this appliance on or near a hot gas or electric burner or where it could touch a heated oven or microwave. Do not allow this appliance to touch curtains, wall coverings, clothing, dishtowels or other flammable materials during use.
-
Always use the appliance on a secure, dry, level surface.
-
Never leave the appliance unattended when in use.
-
Remove the lid from the deep fat fryer during use.
-
Always carry out regular checks of the power cord to ensure no damage is evident. Should there be any signs that the cord is damaged in the slightest degree, the entire appliance should be returned to the Customer Service Department. For your own safety, only use the accessories and spare parts from the manufacturer which are suitable for the appliance.
-
For your own safety, only use the accessories and spare parts from the manufacturer which are suitable for the appliance.
-
Always return the appliance after a malfunction, or if it has been damaged in any manner to the Customer Service Department for examination, repair or adjustment as special purpose tools are required.
-
Never unplug it from the socket by pulling on the cable.
-
Always ensure that your hands are dry before handling the plug, switch or power cord.
-
The appliance is not intended to be operated by means of an external timer or a separate remote-control system.
-
This appliance shall not be used by children from 0 to 8 years. This appliance can be used by children over the age of 8 and above if they are continuously supervised.
-
This appliance can be used by people with reduced physical, sensory or mental capabilities or lack of experience or knowledge, if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Keep the appliance and its cord out of reach of children aged less than 8 years.
-
Cleaning and maintenance shall not be made by children.
-
Children should be supervised to ensure that they do not play with the appliance.
-
Unplug the appliance as soon as you have finished using it and when you are cleaning it.
-
Ensure the lid and the reservoir do not contain any water before filling the fryer with oil.
-
Should you decide not to use the appliance anymore, make it inoperative by cutting the power cord after removing the plug from the socket. We also recommend making all potentially dangerous parts of the appliance harmless, particularly for children who might be tempted to play with it.
-
Never use the appliance if it is not working properly, or if it has been damaged. Any intervention other than cleaning and normal maintenance by the customer must be carried out by an approved service center.
-
Never immerse any part of the main body, lid, power cord, and plug in water or any other liquid to protect against electrical hazards.
-
This appliance is intended to be used in household and similar applications such as:
– staff kitchen areas, in shops, offices, and other working environments;
– by clients in hotels, motels and other residential type environments;
– Bed and Breakfast type environments
– farmhouses. -
If the appliance is used for other purposes than intended or is it not handled in accordance with the instruction manual, the full responsibility for any consequences will rest with the user. Any damages to the product or other things are not covered by the warranty.
Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling.
Electrical and electronic equipment marked with the symbol indicating a separate collection of such equipment must be returned to a municipal waste collection point.
Appliance description
- Heating element
- Lid
- Basket with handle
- Exterior
- Handle – exterior
- Reset-button
- Storage for the power cord
- Control lamp – red
- Thermostat button
- Thermostat lamp – green
- Reservoir – enameled
Before the first use
Attention: The capacity of this double fryer is 2 x 1800 Watts. Therefore
check the maximum of your electric circuit before you plug in both fryers.
Before you use the appliance for the first time, please do as follows:
Carefully unpack the appliance and remove all the packaging material. Keep the
material (plastic bags and cardboard) out of reach of children. Check the
appliance after unpacking for any visible damage, possibly from
transportation. Place the appliance on a stable and heat-resistant surface.
Remove the lid and the basket. Take out the heating element by pulling it
straight up and also remove the reservoir.
Clean the lid, the basket, and the reservoir with warm soapy water. Dry the
parts thoroughly. Make sure that the parts are completely dry.
Wipe the exterior with a damp cloth and dry thoroughly. Assemble the fryer.
Fill the reservoir with liquid frying oil between the minimum and maximum
level, approx. 2,5 liters. Ensure that you don’t add less than the minimum
capacity or over the maximum capacity. Inside the reservoir, you will find two
lines that indicate the minimum and maximum levels.
Attention: this fryer may only be used with liquid frying oil. Never use hard
fats.
The handle of the basket can be stored in the basket by folding it in. Squeeze
the two handle wires together and push the handle forwards over the locking
clip.
Only store the handle when the oil is fully cooled down. Ensure the handle is
folded back before operating the fryer again!
For the best result in a cool zone fryer, always fry without using the lid.
Frying
Check that the voltage in your home corresponds with the voltage printed on
the bottom of the appliance and plug the fryer in.
Check if the handle is folded back and turn the fryer on by plugging it in.
The red power indicator will light up.
Turn the thermostat button clockwise to the required temperature.
The green thermostat lamp will light up.
Note: always remove the handle out of the oil before heating, otherwise the
plastic handle will melt.
As soon as the desired temperature is reached, the green thermostat lamp goes
out. The thermostat and the thermostat lamp will toggle on and off as the
thermostat in the fryer maintains the correct temperature.
The fryer is now ready to use.
Add the desired quantity of food to the basket. Do not add too much food at
one time (never more than 2/3).
Food should be as dry as possible to reduce the amount of water getting into
the oil. Shake the ice off of frozen products above the sink.
Lower the basket slowly into the oil. If you lower too fast the oil can
splash.
Always fry without the lid. This prevents the fryer from overheating and an
automatic shutdown. At the same time, it ensures a crispier result.
When the food is deep-fried, lift the basket out of the oil. Carefully shake
the excessive fat of and hang the basket on the hook in the reservoir to drain
the oil.
Take the basket out of the fryer and serve the food.
Place the basket back.
After frying
When you have finished frying, turn the fryer off by turning the thermostat
button anti-clockwise completely and pull the plug from the socket.
Only store the handle when the oil is fully cooled down. Ensure the handle is
folded back before operating the fryer again!
Let the fryer cool down for several hours before moving the fryer. If you want
to move the fryer always use both hands.
Tips
- Note: During and after frying it is possible that drops of condensated waterfall into the hot oil. The hard noise you can hear is the reaction of the water with the oil/fat and is normal. It does not influence the use of the fryer.
- Note: Battered or coated food, like fish, may stick to the basket. To prevent this, lower the basket and then place the food in the fryer.
- Never salt the product before or during cooking. This will spoil the oil.
- For the best results, it is advisable not to fry with a full basket, maximum 450 to 500 grams. Fry frozen products in even smaller portions, because they contain more water and cause the oil to cool down too much.
- If you make your own fries, dry them thoroughly after washing to make sure there will be no water in the oil.
Fry the fresh fries in two times. The first time (pre-cooking) 5 to 10 minutes on 170 degrees. Lift the basket, let the oil drain and let the fries cool down for several minutes. For the second time turn the temperature control (cooking) to 190 degrees and cook the fries in 2 to 4 minutes. Lift the basket after frying and let the oil drain.
Safety
Your fryer is provided with double safety, a reset button, and a safety switch.
The fryer is provided with an overheating safety which automatically shuts the fryer off when overheating. Remove the plug from the outlet and allow the fryer to cool down completely. You can switch the fryer on again when you push the reset button on the back in the storage compartment. See 6 in the picture. Use a blunt object to press the reset button in the small round opening. On the front of the heating, you will see a safety switch. If you pull out the heating element while the fryer is still on, the safety switch will shut the element of. This also means that you can not use the heating element when it is not placed or not placed correctly in the retaining slots.
Cleaning & maintenance
FILTERING OR CHANGING LIQUID FRYING OIL
Before changing or filtering the oil, always unplug the fryer and let it cool
down completely. The liquid frying oil can be used longer if you filter it
regularly. Replace the liquid frying oil regularly, after 8 to 12 times.
Filter the liquid frying oil only when it is cold. Pour the oil in a clean
bowl. Clean the reservoir with hot water and a mild detergent or in the
dishwasher. Thoroughly dry the reservoir.
Pour the liquid frying oil back into the reservoir through a fine sieve.
Check each time if the level of the liquid frying oil is between the minimum
and maximum level. When replacing the oil, follow the same steps as described
before. Liquid frying oil can be poured back in the bottles. Never wash away
fat or oil through the sink.
CLEANING THE FRYER
Before cleaning always unplug the fryer and let it cool down completely.
Remove the basket, the element, and the reservoir out of the fryer. Clean the
lid, the basket, and the reservoir in the dishwasher or with hot water and a
mild detergent. Ensure that the parts are dried thoroughly after cleaning.
Clean the exterior of the fryer with a damp cloth and when needed a mild
detergent.
Never use any abrasives! Never immerse the heating element, power cord or plug
in water or other liquids.
General terms and conditions of service and warranty
We do not need to remind you of the importance of service. After all, we develop our products to a standard so that you can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are entitled to a solution straight away. Hence our products come with an exchange service, on top of the rights and claims you are entitled to by law. By exchanging a product or part, we save you time, effort, and costs.
2-year full manufacturer’s warranty
- Customers enjoy a 2-year full manufacturer’s warranty on all Inventum products. Within this period, a faulty product or part will always be exchanged for a new model, free of charge. In order to claim under the 2-year full manufacturer’s warranty, you can either return the product to the shop you bought it from or contact the Inventum customer service department via the form at www.inventum.eu/service-aanvraag.
- The 2-year warranty period starts from the date the product is bought.
- In order to claim under the warranty, you must produce a copy of the original receipt.
- The warranty applies only to normal domestic use of Inventum products within the Netherlands.
Breakdowns or faults outside the warranty period
- Breakdowns or faults in small or large domestic appliances outside the warranty period can be reported to the customer services department via the form at www.inventum.eu/service-aanvraag or by calling the customer services department.
- The customer services department may ask you to send the product for inspection or repair. The costs of dispatch will be at your expense.
- The inspection to establish whether the repair is possible involves a charge. You need to grant your permission for this, in advance.
- In the event of a large domestic appliance, Inventum, at your request, can send out a service engineer. In that case, you will be charged the call-out costs, as well as parts and labor.
- In the event of an instruction to repair, the repair costs must be paid in advance. In the event of a repair by a service engineer, the costs of the repair must be settled with the engineer on-site, preferably by means of PIN payment.
Warranty exclusions
-
The following is excluded from the aforesaid warranties:
• normal wear and tear;
• improper use or misuse;
• insufficient maintenance;
• failure to comply with the operating and maintenance instructions;
• unprofessional installation or repairs by third parties or the customer himself;
• non-original parts used by the customer;
• use for commercial or business purposes;
• removal of the serial number and/or rating label. -
In addition, the warranty does not apply to normal consumer goods, such as:
• dough hooks, baking tins, (carbon) filters, etc.;
• batteries, bulbs, carbon filters, fat filters etc.;
• external connection cables;
• glass accessories and glass parts such as oven doors;
• and similar items. -
Transport damage not caused by Inventum is also excluded. Therefore, inspect your new device before starting to use it.
If you detect any damage, you must report this to the store where you purchased the product within 5 working days, or to the Inventum customer service department via the form at www.inventum.eu/service- aanvraag. If transport damage is not reported within this period, Inventum does not accept any liability in this respect. The following are excluded from warranty and/or replacement: faults, loss of, and damage to the device as a result of an event that is normally insured under the home contents insurance.
Important to know
- The replacement or repair of a faulty product, or a part thereof, does not lead to an extension of the original warranty period.
- If a complaint is unfounded, all costs arising from it will be at the customer’s expense.
- Following the expiry of the warranty period, all costs of repair or replacement, including administration costs, dispatch, and call-out charges, will be charged to the customer.
- Inventum cannot be held liable for damage caused by external events unless this liability arises from mandatory statutory provisions.
- These warranty and service provisions are governed by Dutch law. Disputes will be settled exclusively by the competent Dutch court.
Inventum Huishoudelijke
Apparaten B.V.
Postbus 5023
6802 EA Arnhem
instagram.com/inventum1908
facebook.com/inventum1908
youtube.com/inventum1908
Modifications and printing errors reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>