anko 43108138 Dual Gas Lift Monitor Arms Instruction Manual

: June 6, 2024
: Anko

Table of Contents

PRODUCT DIMENSIONS
TOOLS REQUIRED THAT ARE NOT INCLUDED
PARTS INCLUDED
Grommet installation
Desk Clamp installation
WARNING
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Dual Gas Lift
Monitor Arms
Installation Manual

INSTRUCTION MANUAL
43108138
43108138 – Dual Gas Lift Monitor Mount_IM_V1
Artwork Proof Date: 07.092021

PRODUCT DIMENSIONS

TOOLS REQUIRED THAT ARE NOT INCLUDED

PARTS INCLUDED

DON’T GET HURT!!! The Gas Spring Arm has been preset for a 6.5kg monitor. Please hold the folded arm tightly and open it slowly when removing it from the packaging.

Remove the cable tie and take care to allow the rebound slowly. Beware of sudden spring-back of the arm.

Grommet installation

Loosen the two screws on the base, pass it through a hole in the desk or clamp and tighten to flat table edge, screw in the two screws that you have just loosened.

Desk Clamp installation

Attach the desk clamp to the aluminum base.

TEIr?shut?entlinn:s1Trigac I;TcPhITZdu ‘btu’ rclicritimpt i = rgn’Acs: n

Flush surface installation: Install the upper two screws and don’t screw them tight. Leave some space and hang the monitor on the head plate.

Flush surface installation: Install the lower two screws and fasten the upper two screws.

Recessed surface installation:

Put spacers between headplate and monitor. Install the upper two screws and don’t screw them tight. Leave some space and hang the monitor on the head plate.

Recessed surface installation:

Put spacers between headplate and monitor. Install the lower two screws and fasten the upper two screws.

Use a hex wrench to adjust the height tension of the gas spring arm, to keep the different weights of monitors still in any position.

Insert cables into cable covers. Leave enough slack of cables at arm joints for full adjustment.

WARNING

Prior to the installation of this product, the installation instructions must be read and completely understood. Failure to do so may result in personal injury, property damage, or voiding of factory warranty.

Do not install on a structure that is prone to vibration, after movement, uneven or chance of impact. Reinforce the structure as required before installation.

The desk clamp can support a maximum thickness of 9 cm. Check the desk edge before installation.

Pay attention to the weight capacity of the mount. Exceeding the limit can result in dysfunction or even serious personal injury and property damage.

Never operate the mount if parts are missing or damaged. Contact your local service center for warranty service.

Do not push, pull fiercely. Do not pull the clamp oppositely from the desk. Never shake the base. Ensure the unit is used only on a flat surface. Do not use this unit unless all bolts and screws are firmly secured. Check and tighten all parts regularly. Not a toy, not for children to play with.
LASER All rights reserved.