Shenzhen Keshilian Electronic Technology KT16 Remote Control Instructions
- June 6, 2024
- Shenzhen Keshilian Electronic Technology
Table of Contents
Shenzhen Keshilian Electronic Technology KT16 Remote Control
Features:
Low cost ‐ Referring to another duplicator, yeah;
Charming shape‐ Suitable for handheld;
Colorful ‐ A red button is special;
Check before send ‐ Don’t worry the quality issue!
Compatibility:
2260(all manufacturers), 2262(All manufacturers), PT2264, 5326(All
manufacturers), SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014,
SMC918series, 527(All manufacturers), 1527(All manufacturers),
2240(All manufacturers) .
Note:
It can’t copy original car remote control, two‐way remote control and
rolling code remote control (Rolling code chips start with HCS commonly, such
as HCS200, HCS201, HCS300, HCS301, etc.) Instruction:
Clear Out Code:
Press the A button and B button at the same time, the LED indicator
will enter into the fast flashing status, it means that all the memory data
is cleared (Please see the video above). You can repeat the above operating
steps if the memory clear operation is not successful.
Duplicating (Learning)/Face to Face Copying(One to One Copying):
After clearing the memory, you can operate Face to Face Copying(One to One
Copying), your left hands press the original remote control and your right-
hand press the duplicating remote control at the same time; Put the two remote
controls together as close as possible. For example, press the Button A of the
2 remote controls at the same time, the LED Indicator flashes fast, and you
press the Button A of the duplicating remote control again, the LED
indicator long light, it means that the original remote control of the A
button A code has been copied into the duplicating remote control. The other 3
buttons are the same operation.
FCC RULES
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions : (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>