soundmaster CD9290 Portable CD Player with Radio DAB + CD User Manual

CD9290

ENVIRONMENTAL PROTECTION

Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual, or packaging
The materials are reusable according to their markings. By reusing, recycling, or other forms of utilization of old devices you make an important contribution to the protection of our environment.
Please contact your local authorities for details about collection points.

|

WARNING

|
---|---|---

Risk of electric shock Do not open!

Caution: To reduce the risk of electric shock, do not remove the cover (or back). There are no user-serviceable parts inside. Refer servicing to qualified service personnel.

This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.
This symbol indicates the presence of important operating and maintenance instructions for the device
Used batteries are hazardous waste and NOT to be disposed of with household waste! As a consumer you are legally obligated to return all batteries for environmentally responsible recycling – no matter whether or not the batteries contain harmful substances)
Return batteries free of charge to public collection points in your community or shops selling batteries of the respective kind. Only return fully discharged batteries ) marked Cd = cadmium, Hg = mercury, Pb = lead

• Only use mercury and cadmium-free batteries.
• Used batteries are hazardous waste and NOT to be disposed of with household waste!!!
• Keep batteries away from children. Children might swallow batteries.
• Contact a physician immediately if a battery was swallowed.
• Check your batteries regularly to avoid battery leakage.
• Batteries shall not be exposed to excessive heat such as sunshine, fire, or the like.
• CAUTION: Danger of explosion if the battery is incorrectly replaced
• Replace only with the same or equivalent type

CAUTION – INVISIBLE LASER RADIATION WHEN OPENING THE COVER OR PRESSING THE SAFETY INTERLOCK. AVOID EXPOSURE TO THE LASER BEAM.
To prevent possible hearing damage, do not listen at high volume levels for long periods

• Use the device in dry indoor environments only.
• Protect the device from humidity.
• This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries. Safety, Environmental and Setup Instructions
• No objects filled with liquids, such as vases, shall be placed on the apparatus.
• The mains plug or an appliance coupler is used as the disconnect device, the disconnect devices shall remain readily operable.
• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.
• Make sure the main cable stays dry during operation. Do not pinch or damage the main cable in any way.
• A damaged mains cable or plug must immediately be replaced by an authorized service center.
• In case of lightning, immediately disconnect the device from the main supply.
• Children should be supervised by parents when using the device.
• Clean the device with a dry cloth only.
• Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
• Do not expose the device to direct sunlight or other heat sources.
• Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
• Do not cover the ventilation openings!
• Install the device at a safe and vibration-free location.
• Install the device as far away as possible from computers and microwave units; otherwise, radio reception may be disturbed.
• Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.
• No naked flame sources, such as lighted candles, should be placed on the unit.
• When you are necessary to ship the unit store it in its original package. Save the package for this purpose.
• In case of malfunction due to electrostatic discharge or fast transient (burst), remove and reconnect the power supply.
• If the unit is not used for a long period of time, disconnect it from the power supply by unplugging the power plug. This is to avoid the risk of fire.

LOCATION OF CONTROLS

UNIT

1. DC jack
2. Phone jack
3. MENU / P-FUNC button
4. EQ / HI VOL. button
5. SKIP / DOWN button
6. OK / INFO, PLAY / PAUSE button
7. OPEN knob
8. POWER button
9. SKIP / UP button
10. ASP / PRE button
11. MODE button
12. VOLUME knob
13. RECHARGE SWITCH (at the bottom)
14. STOP / SEARCH button
15. LCD display
16. Battery Compartment (at the bottom)

INSTALLATION

Content of Delivery

• Main Unit
• Headphone
• AC Adapter
• Instruction Manual

Battery Installation
A T T E N T I O N !!!
On operation with standard/conventional batteries, be sure that the charging switch „RECHARGE“ is on the „OFF“ position, otherwise, the batteries may become hot and explode.

1. Open the Battery Compartment cover.
2. Insert 2 batteries ( UM-3, “AA”, LR6 or equivalent ) in the correct polarity as indicated. Heavy-duty batteries are recommended and close the clover.

Note:

• If you want to use the CD player with batteries, disconnect the AC/DC adapter and set the
  RECHARGE switch to the „OFF” position.

• Please do not mix old and exhausted batteries or different types.

• Please remove the batteries when not in use for a longer period of time.

AC Adapter

1. Make sure that your main supply matches the type plate of the main adapter.
2. Connect the AC adapter cable to the DC power jack and the AC adapter to a wall outlet.

Rechargeable battery operation

1. Open the battery compartment cover and insert two of the recommended rechargeable batteries, matching polarity. (Both batteries must be of rechargeable nickel-cadmium type, otherwise, the batteries may explode or leak).

2. Plug in the AC adaptor and set the Recharge switch to ON position to start charging. (Use only the AC adaptor supplied with the set for charging.)

3. After 15 hours. Please unplug the AC adaptor and switch the Recharge switch to the “OFF” position (Do not charge continuously for 24 hours or more. Doing so can cause the performance of the rechargeable battery to deteriorate).
   Note: You may play DISCS whilst charging the batteries.

4. If the operating time decreases drastically even when the rechargeable nickel-cadmium batteries are properly recharged, purchase a new set of rechargeable nickel-cadmium
   batteries.

When charging for the first time or after a long time, playing time may be reduced. In this case, charge and discharge the batteries several times.

Low Battery Alert
When the low battery indicator appears on the display, please prepare to replace the new batteries.
Automatic Turn Off
IMPORTANT! If the player is in CD mode in Stop function for approximately 30 seconds, the player will turn off automatically.

BASIC OPERATIONS

Unit On/Off
Turn unit on: Push the “POWER” button in standby mode.
Turn unit off: Push the “POWER” button during on mode.
Selecting Modes
In on mode, press the “MODE” button repeatedly to switch between the modes.
Adjust the volume
Rotate the Volume knob to adjust the desired volume.
Switch off the volume restrictio n
To protect your hearing, after switching on the device, only reduced volume is available. You can switch off this “Volume restriction”.
Press and hold the “EQ / HI VOL” button to de-activate the volume restriction.
Note: The volume restriction is reactivated after switching off or changing the disk.
Anti-Shock Function
The player has an Anti-Shock function. The function is automatically switched on when MP3 is used. For audio CD playback, press the “ASP / PRE” button. “ASP” appears in the display. Todeactivate the anti-shock function, press the “ASP / PRE” key again.

CD

1. Insert the headphone plug to the “PHONE JACK”.
2. Slide the “OPEN” knob to the right side and the CD door opens. Put a disc into the CD compartment with the label side upward and close the CD door.
3. The player now reads the CD, which may take a few seconds.

General Operation
PLAY/PAUSE button

• Press once to start the playback.
• Press once again to interrupt the playback.

STOP button

• Press once to stop the playback.
• Press the button once again to turn off the player.

SKIP button

• Press the button to skip to the next track or to the previous track .
• Press and hold the button to search forward backward.

MENU / P-FUNC

• Press and hold the button to change the folder (for MP3CD)

Resume function
This player is equipped with a resume function. That means the CD will start automatically at the position, where the CD was stopped by last use.
ATTENTION! This function works only when no other disc was inserted meantime into the player. If you wish to start with track 1, press the button repeatedly until track 1 is shown in the display.
Playing modes
Press repeatedly the “MENU / P-FUNC” button during the playback to change the following functions:

During CD playback

During MP3-CD Playback

Program Play
For Audio-CD

1. In stop mode, press the “MENU / P-FUNC” button. “CD P01” will appear and “00 PROG” is flashing in the display. “P01” means the program number and “00” means the tracking number.
2. Press the button to select the desired track.
3. Press the “MENU / P-FUNC” button to enter the track into the memory.
4. Repeat steps 2 – 3 until all desired tracks are stored (max. 64).
5. Press the button to start the playback. On the right side of the display will appear the program indicator “P”.
6. To stop the playback, press the “STOP “button.
7. To erase the program memory, stop the playback.

For CD-MP3

1. In stop mode, press the “MENU / P-FUNC” button. “CD P01” will appear and “000 PROG” is flashing in the display. “P01” means the program number and “000” means the tracking number.
2. Press and hold the “MENU / P-FUNC” button to select the desired folder.
3. Press the button to select the desired track.
4. Press the “MENU / P-FUNC” button to enter the folder and the track into the memory.
5. Repeat steps 2 – 4 until all desired tracks are stored (max. 64).
6. Press the button to start the playback. On the right side of the display will appear the program indicator “P”.
7. To stop the playback, press the “STOP ” button and the program memory will be erased.

DAB

NOTE: The headphone cord works as an antenna. To ensure the maximum tuner sensitivity, always keep the headphone cord fully extended!

1. Insert the plug of your headphone into the phone jack “PHONES”
2. Press the “POWER” button to turn on the unit.
3. Press repeatedly the “MODE” button to select the “DAB” mode.
4. If you select the DAB mode for the first time, the unit starts automatically a full scan and store all available radio stations or you press the “SEARCH” button to start an automatic scan. The display shows the number of the found stations.
5. Select with the button the desired radio station and press “OK” to confirm.

Save Preset Station

1. Select with the button the desired radio station and press “OK” to confirm.
2. Press and hold the “ASP / PRE” button until “Preset store” is shown in the display.
3. Select with the button the desired station number and press “OK” to confirm.

Recall Preset Station

1. Press the “ASP / PRE” button. The display shows “Preset recall” in the display.
2. Select with the button the desired station number and press “OK” to confirm. The unit starts to play the selected radio station.

Information
Press repeatedly the “OK / INFO” button to show the following information: DLS, Genre (PTY), Channel/Frequency, Time/Date, Bitrate.

FM

NOTE: The headphone cord works as an antenna. To ensure the maximum tuner sensitivity, always keep the headphone cord fully extended!

1. Insert the plug of your headphone into the “PHONO JACK”
2. Press the “POWER” button to turn on the unit.
3. Press repeatedly the “MODE” button to select the “FM” mode.
4. Press the “SEARCH” button press and hold the or button to start an automatic scan. The unit stops at the next available radio station.
5. To tune the frequency manually, press the button. The unit tune in 50kHz steps.

Save Preset Station
Is the same as in DAB mode.
Recall Preset Station
Is the same as in DAB mode.
Information
Press repeatedly the “OK / INFO” button to show the following information:
Radio Text, Genre (PTY), Time/Date, Frequency.

EQUALIZER

NOTE! The EQ function is only available in CD mode!
During playback, you can choose between the following sound effects: ”BASS, POP, JAZZ, ROCK, CLASSIC” by pressing the “EQ / HI VOL” button repeatedly. To turn off the effects, press the “EQ / HI   VOL” button repeatedly until the “Sound Effects” indicator disappears.

SYSTEM SETTINGS

In DAB or FM mode, press the “MENU / P-FUNC” button to enter the system settings menu. Select with the button one of the following settings and press “OK / INFO” to confirm.

• Date/Time
  Manual adjustment of date and time

• System version
  Show the currently installed software version
  Factory reset
  NOTE: When resetting the device to factory settings, all stored stations and settings are deleted! Select “Yes” with the button and press “OK / INFO” to confirm. The display shows “Restarting”. After the restart, the unit starts automatically a new DAB station scan.

• Language
  Select with the button the desired menu language and press “OK / INFO” to confirm.

Technical changes and misprints reserved.
Copyright by Woerlein GmbH, 90556 Cadolzburg, www.soundmaster.de
Duplication only with the permission of Woerlein GmbH

TECHNICAL SPECIFICATIONS

Manufacturer – AC adaptor| Wörlein GmbH, Gewerbestrasse 12,
D-90556 Cadolzburg
www.soundmaster.de
HRB-Nr. 771 bei Amtsgericht
Fürth/Bay.
---|---
AC adaptor – Model identifier| GKYPS0060045EU1
Power input| 100-240V~ 50/60Hz  0.3A max.
Power output| 4.5V  0.6A   2.7W

Average active efficiency| ≥ 67%
No load power consumption| ≤ 0.1W
Battery operation| 2 x UM-3/AA 1.5 Battery
DAB range| 174 – 240 MHz
FM range| 87.5MHz – 108.0MHz
Preset station| 20 DAB, 20 UKW (FM)
Audio socket| 3.5mm

HERSTELLER / IMPORTEUR

Wörlein GmbH
Gewerbestraße 12
D 90556 Cadolzburg, Germany
Tel: +49 9103 71 67 0
Fax: +49 9103 71 67 12
E-Mail: info@soundmaster.de
Web: www.soundmaster.de

Hereby, Wörlein GmbH declares that this device is in
compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU.
A copy of the declaration of conformity can be obtained
from the above address.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>