Keycafe Key Management System Owner’s Manual
- June 6, 2024
- Keycafe
Table of Contents
Key Management System
FCC Statement
Contains Transmitter Module FCC ID: 2AELPNFC
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. This product should
not be used in a residential installation. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: · Reorient or relocate
the receiving antenna. · Increase the separation between the equipment and
receiver. · Connect the equipment into an outlet on a circuit different from
that to which the receiver is
connected. · Consult the dealer or an experienced radio/TV technician for
help.
· This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
· Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
ISED Statement
Contains Transmitter Module IC: 24333-NLP
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. Le
présent appareil est conforme aux CNR d’lndustrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes: (1) l lappareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, méme si le brouillage est susceptible d’en compromettre le
fonctionnement.{quote} Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Conformément d la réglementation dlndustrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectrique d l’intention des autres
utilisateurs, il faut choisir le type dantenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
This radio transmitter (identify the device by certification number, or model
number if Category Il) has been approved by Industry Canada to operate with
the antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included
in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.
Conformément d la réglementation dlndustrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectrique d l’intention des autres
utilisateurs, il faut choisir le type dantenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité
nécessaire d l’établissement d’une communication satisfaisante.
Approved Antennas: PCB trace antenna is part of the transmitter circuit.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>