CELL STAR Rok 1 Mobile Phone User Manual

User Manual

Declaration
Please read the user’s manual to keep your mobile phone in the best condition. The manual has been verified and reviewed to guarantee accuracy. Instructions and descriptions contained herein are accurate at the time of publication. However, mobile phones developed afterward, and the contents of their manual are subject to modification without further notification. Our company reserves the rights in relation to the manual.

Introduction

• Password
  Phone password
  With the phone password, you can prevent others from using your mobile phone without your approval. The original phone password is 1234.

•  Insert the sim card and the battery
  Ensure to turn off the equipment and disconnect with the charger before taking out the battery.

• Startup and shutdown
  Press the key of the power supply to start up or shut down the mobile phone.
  If it is prompted to input PIN or UPIN, please input the required password (shown as **** on the screen).

• Antenna
  Your mobile phone may be provided with built‐in and exposed antenna. Just like using any other radio and transmitting devices, don’t touch the antenna if not necessary because it may affect the quality of telecommunication and result in equipment operating in an energy level higher than required, thus shortening the service life of the battery.
  2. Input Methods
  Need to be sure to change one of the Input Methods.
  3. Phone Book
  You may save the information of contacts including names & telephone numbers in the phone book. The storable entries of sim cards depend on the type of card.
  4. Message

• SMS
  The cell phone supports sending of and receiving of SMS. You may check the quantities of sent and received messages from the menu of the SMS counter.
  Write a message: You may select multiple receivers to send the message to more than 1 person. SMS setting: You may select to edit the SMS setting either of SIM card 1 or 2, where, you can edit the number of the service center (Which is obtained from the service provider).
  5. Settings

• General
  Security setting
  You may set functions in relation to cell phone security. [phone lock:1234] Restore the factory settings
  Enter the correct password of the phone will have to change your phone settings back to factory default state value, the user of the function be used with caution. (Default password: 1234).

• Phone
  Network setting
  The option is related to your network provider. Please get in contact with the network provider for that.
  Flight Mode: No communication function is an available in‐flight model. Switch mode
  You may select modes of dual‐standby and single‐pass, SIM 1 on/SIM 2on, and flight mode.
  6. WAP
  You may surf online with WAP Brower, which means that you may surf online at any time and in any place. For details, please get in contact with the nearest network service provider.
  7. Video recorder
  In the options of the video camera, you may set the exposure compensation, avoidance of flickering, white balance, special effect, profile etc.
  8. Camera
  In the options of camera, you may set the photometry mode etc. You may enter the album to check the formats that the cell phone supports.
  9 . Audio Player
  The music player is used to play music files in supported formats in the current player’s list.
  10. Video player/Image Viewer
  Check the video or pictures files supported by the cell phone.
  11. File manager
  For the memory card, you may establish a data file folder etc.
  12. Call history
  The call list lists all types of calls, including missed ones, dialed ones and answered ones, or you may enter the separate lists of missed calls, dialed calls and answered calls for check or operation.
  13. FM Radio
  Turn on/FM broadcast, and you may manually tune the channel.
  14. Recorder
  Usethisfunctionyoucanrecordorlistentoyourownrecord.
  15. Connection
  Edit and set the GPRS access point
  Note: The “account data” is to be provided by the network operator.
  16. Alarm
  Set the time of the alarm clock. At the time of the alarm clock, an alarm ring will be given as per the setting.
  17. Bluetooth
  You may establish a wireless connection with other compatible devices with the Bluetooth
  technology.
  18. PC connect

• Mass storage
  Use the T‐Flash inserted in the mobile phone as U‐Disk.
  19. Lamp
  Support Lamp function.
  20. Calendar
  Support Calendar function.
  21. Calculator
  Support Calculator function
  22. Original Accessories
  Refer to the local dealer for the supply of accessories. Hereafter are some precautions for usage of the accessories:

1. Please keep the accessories out of children’s reach.
2. Hold the plug and pull out instead of pulling the power cord when cutting off the power supply.
3. Regularly check the mobile equipment in the automobile to see whether they are correctly installed and whether work normally.
   Only use batteries, chargers, and accessories approved by the manufacturer. Usage of other types of batteries, chargers and accessories may result in the violence of the certification or warranty terms or even lead to danger.
   Why is required to use the original accessories?
   Battery and charger are key parts of a mobile part because they play important roles in guaranteeing the normal operation of the mobile phone as well as your safety. It is shown in our long‐term customer investigation and aftersales service that lots of mobile phone failures result from the usage of ineligible accessories, especially ineligible batteries and chargers. Hazards resulting from usage of ineligible battery and charger
4. Shorten the battery service life with times of battery charging/discharging much fewer than that of the original battery.
5. Shorten the service life of the mobile phone largely. The unstable voltage will affect the normal operation of the circuit, resulting in permanent damage.
6. Affect the performance and reliability of the mobile phone, reducing the voice quality and being susceptible to the halted system.
7. May result in bumping or explosion and thus endanger the personal safety of the customers.
   23. About the battery

• Charging and discharging
  A chargeable battery is used for the equipment. The battery may be charged and discharged for several hundreds of times and finally will be disabled. In case the standby time and call duration shorten obviously, please replace the battery. If the battery is replaced and used for the first time, or the battery has been kept for a long time before using, it may be necessary to connect with the charger, disconnect and then reconnect in order to charge the battery. When the charger is not used, please disconnect with the equipment and plug it out from the power socket.
  If the battery runs out of electricity, you may have to wait for a few minutes till the symbol of chargingisshownonthescreen, and then you canmakeandans weranycall.
  Don’t use the battery for any other purpose. Don’t use any damaged charger or battery.

•   Usage and treatment of battery
  Avoid short circuit of battery; otherwise, the battery may be damaged, and generate heat to cause fire hazard;
  Don’t put the battery under high temperature or in fire; otherwise, it may explode;
  Don’t attempt to take apart the battery;
  Stop usage in case of damage or obvious aging of battery and charger;
  Return waste and used batteries to the supplier or specified recovery site.
  Don’t throw it away in domestic garbage.
  24. Maintenance and service
  Your equipment is a product with exquisite design and process. Please use it carefully.
  Following are some suggestions for you to effectively use the maintenance service.

1. Keep the equipment dry. Rainwater, moisture, other liquids or moisture contents may contain mineral matters, which may erode the electronic wires. If the equipment is wetted, please take out of the battery till the equipment is totally dried and then put in the battery.
2. Don’t use or store the equipment in dusty or filthy places; otherwise, the detachable parts and electronic elements may be damaged.
3. Don’t put the equipment in overheated places.
4. Don’t keep the equipment in under-cooled places; otherwise, when the temperature rises to normal, moisture may be generated within the equipment, resulting in damage of the circuit board.
5. Please open the equipment as per the descriptions in the manual. Don’t try any other means.
6. Don’t throw, knock or shake the equipment. Any rough treatment of the equipment may result in damage of the inner circuit board and its exquisite structure.
7. Don’t clean the equipment with ardent chemicals, detergents or strong wash.
8. Don’t paint any dyestuff on the equipment. Painting may block foreign substances in detached parts and thus affect the normal operation.
9. Clean the lens with a clean, dry soft cloth (such as the camera lens, range sensor, and light sensor).
10. Only use matched or approved antenna for the substation of the damaged one. Unapproved antenna, alteration or accessories may result in damage of the equipment and violence of relevant specifications on radio equipment.
11. Please use the charger in an indoor area.
12. Back up data that should be kept (such as the address directory and calendar memorandum).
13. Please turn off the equipment and take out the battery to restore the equipment setting irregularly to maintain the optimal performance.
14. The above suggestions also apply to your equipment, battery, charger, and other accessories. In case any device doesn’t work, please take it to the nearest authorized maintenance agency for

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
   (1) This device may not cause harmful interference.
   (2) This device must accept any interference received, including interference that may cause undesired operation.

2.  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE :
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
SAR Information Statement
Your MOBILE PHONE is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal  Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluations of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of thephone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted a requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 0.40 W/Kg and when worn on the body, as described in this user guide, is 0.73W/Kg(Body‐worn measurements differ among phone models, depending upon available accessories and FCC requirements). While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of
http://www.fcc.gov/out/flaccid after searching on
FCC ID: 2AUWK‐ROK1 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Association (CTIA) web‐site at http://www.wow‐com.com. In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a sub‐ substantial margin of safety to give additional protection for the public and to account for any variations in measurements.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>