DEFA 1x35A/2x35A MultiCharger/Marine Charger/Rescue Charger User Guide

: June 6, 2024
: DEFA

Table of Contents

ABOUT THE CHARGER
AVAILABLE ACCESSORIES
CHARGE PROCESS
INSTALLATION
MAINTENANCE
SAFETY
WARRANTY
TECHNICAL INFORMATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MultiCharger/MarineCharger/RescueCharger
1x35A/2x35A

User guide

ABOUT THE CHARGER

DEFA MultiCharger/MarineCharger/RescueCharger 1x35A and 2x35A are based on modern switch-mode technology and galvanized divisions. These chargers represent the latest technology within battery charging and will give the batteries optimum life.
It is well suited to battery sizes up to approx. 600Ah and can maintenance charge the battery for an unlimited time. The charger can stand parallel charging up to 20A parallel consumption at the same time as it charges the batteries. The charging voltage is temperature compensated with external sensor. DEFA MultiCharger/MarineCharger/RescueCharger 2x35A has two separate charge outputs and each output has a separate temperature sensor and remote LED.
To satisfy customers with different needs the charger comes without a fixed charging cable. This has to be obtained separately and there are several different lengths available, as well as remote LED panel. See accessories list below.

AVAILABLE ACCESSORIES

Item number	Name	Item number	Name
705294	5m Remote LED Panel 1×35	705165	25m Remote LED Panel 2×35
705295	10m Remote LED Panel 1×35	705099	2m Charge cable
705296	20m Remote LED Panel 1×35	705147	4m Charge cable
705297	25m Remote LED Panel 1×35	705159	6m Charge cable
705162	5m Remote LED Panel 2×35	705160	8m Charge cable
705163	10m Remote LED Panel 2×35	704924	Bracket 1x35A
705164	20m Remote LED Panel 2×35	704925	Bracket 2x35A

CHARGE PROCESS

See Picture on page 4. The Picture shows the charge process in a graph with Voltage (V) and Current (I) over time (t)

The LED on the front of the charger shows the charger status:
Green pulse - Charging
Solid green - Fully charged
Red pulse - Error

INSTALLATION

Read the user manual carefully. Wrong installation can result in damage to the equipment and possible injury. If there are any uncertainties, please contact DEFA or a qualified person. Fix the charger properly where it is to be installed. See drill guide on page 4. Connect the charger according to the diagram on page 5. The charger is intended for use with lead/acid, AGM and GEL batteries, but the battery manufacturers recommendations should always be taken into consideration. The charger has to be installed with the connectors facing downwards to maintain IP rating 44.

Some vehicles have a battery management system. Connect ground according to the vehicle manufacturer’s recommendation.
NOTE: To make sure the correct charging voltages the charging cables must not we shortened or made longer NOTE: Route the cables onto the contacts on the battery charger (Page 3, picture 1) so that they are straight, in order to prevent the PlugIn contacts from being bent or twisted (Page 3, picture 2).

MAINTENANCE

The charger is maintenance free. All batteries should be inspected monthly as a minimum to achieve the best possible safety. The charging process is in such way that the batteries remain fully charged without further water consumption than normal evaporation. 6

SAFETY

Please read the manual carefully before use.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Do not attempt to charge no-rechargeable batteries.
After use, disconnect the mains power before disconnecting from the battery.
Only use the charger in well-vented area and on vented batteries.
This charger has to be repaired by professionals.
The charge output is protected against short circuiting and wrong connections.
The charger does not draw current from the battery when the main power is not connected.
Do not install the charger in a highly flammable environment.
Do not charge a damaged battery.
During charging, battery gas which is very explosive can be developed. Take care not to have sparks, open flames, cigarettes or similar in the vicinity of the battery.
The acid in the battery is corrosive and harmful. It damages clothes, metal and varnish. In case of spillage and contact with skin, wash and rinse thoroughly with water and consult a doctor. · Lead and other chemicals that are used in batteries are toxic. Wash skin and hands thoroughly after working with batteries.

WARRANTY

The guarantee applies to faults in production and materials for 2 years from date of purchase. The customer must deliver the product back to the place of purchase together with the receipt. The guarantee shall cease to apply if the charger is handled negligently, opened or repaired by someone other than DEFA or an authorized representative of DEFA. DEFA has no other guarantee than this and will not be responsible for other costs than those referred to, i.e. no possible additional costs. Neither is DEFA bound by any other guarantee.

TECHNICAL INFORMATION

Model	1x35A	2x35A
Item no.:	708501/708503/708505	708502/708504/708506
Mains Voltage [VAC]	230
Temperature Range [°C]	-35 +50
Charging Voltage* [VDC]	14,4
Maintenance [VDC]	13,5
Current [A]	35	2×35
Battery Size Max. [Ah]	600	2×600
IP rating [IP]	44
Weight [kg]	1,6	3,3
Measure (H/W/D) [mm]	200x98x53	200x190x53
Protection class	1
Acceptance	EN60335-1, EN60335-2-29, EN55014-1, EN55014-2, EN61003-3/2