Tristar SZ-2174 Cyclone Vacuum Cleaner User Manual
- June 15, 2024
- Tristar
Table of Contents
Tristar SZ-2174 Cyclone Vacuum Cleaner
PRODUCT INFORMATION
- Item number; SZ-2174
Item description: Bagless Vacuum Cleaner
The unequivocal identification of the product (type of product, trademark, trade name, model and possibly serial number
Vacuum cleaner
- 220-240V~ 50/60Hz 800W
- Model No.: SZ-2174
- Batch NO: T 14 7 65
Tristar Europe B.V. Jules Vemeweg 87
5015 BH Tilburg The Netherlands
A disassembly map or exploded view
- Connector (PP)
- Inlet seal (PVC)
- Inlet seal of dust cup cover (ABS)
- Outlet seal of dust cup cover (ABS)
- Dust cup cover (ABS)
- Hepa
- Dust cup lock (ABS)
- Spring of dust cup lock (ABS)
- Bottom of dust cup lock (ABS)
- Dust Cup
- Universal wheel
- The front ring of the motor
- Motor
- The rear ring of the motor
- Outlet sponge
- Rear wheel
- Up handle (ABS)
- Low handle (ABS)
- Up cover (ABS)
- Airlet cover (ABS)
- Seal of air outlet (ABS)
- Air outlet (ABS)
- Middle cover (ABS)
- On/off spare part (ABS)
- Spring of on/off button
- On/off switch
- Motor cover (Reinforced PP)
- Bottom base (PP)
- Outlet sleeve (PVC)
Wiring and connection diagrams
- Electronic Boards Diagrams (1.1.D)
- Not Applicable
- List of Necessary Repair and Test Equipment (1.1.E)
- Not Applicable
- Technical Manual of Instructions for Repair (1.1.F)
- Not Applicable
- Diagnostic Fault and Error Codes (1.1.G)
- Not Applicable
- Component and Diagnosis Information (1.1.H)
- Not Applicable
- Instructions for Software and Firmware (Including Reset Software) (1.1.I)
- Not Applicable
- Information on How to Access Data Records of Reported Failure Incidents Stored on the Product (1.1.J)
- Not Applicable
- Technical Bulletins (1.1.K)
- Not Applicable
- Recommended Operations, Safety, and Repair Instruction, Any Implications for the Guarantee (1.1.L)
- Not Applicable
- How to Get Access to Professional Repairers (1.1.M)
- Not Applicable
- Failures Detection and Required Action (Consumer’s Approach) (1.1.N)
- Not Applicable
Troubleshooting
Fault: The machine does not operate
- Possible causes:
- No power is plugged in.
- The switch is not in the “ON” position.
- The socket has no power.
- The motor overheats and the thermal protection starts.
- Methods of resolution:
- Plug in the power and turn on the switch.
- Press the switch button.
- Check the fuse or circuit breaker.
- Check the dust cup and allow the motor to cool naturally for 2 hours, then turn on the switch.
Fault: The suction of the vacuum cleaner is not enough
- Possible causes:
- The dust cup is full or blocked.
- The hose is damaged.
- The hose is poorly connected.
- The suction nozzle is blocked.
- Methods of resolution:
- Clean the dust cup or check the exhaust device.
- Replace the hose.
- Reinstall the hose.
- Check the exhaust hole of the suction nozzle.
User and maintenance instructions
IMPORTANT
- Ensure the safe and correct use of your product by thoroughly reading this operation manual before operating.
- To avoid shortening the lifespan or damaging your product, use only the original spare parts or accessories recommended by this manual.
- Do not allow children or unsuitable persons to operate the system.
- Place the vacuum cleaner on a flat surface when in operation.
- Avoid touching the main plug with wet hands and operating the machine in excessively wet environments.
- Do not insert any object into openings and ensure openings are not blocked by dust, lint, hair, or anything that may reduce airflow.
- Keep hair, loose clothing, fingers, and all body parts away from openings and moving parts.
- Do not use the machine for vacuuming hot or burning objects, including ash.
- Turn off the control before unplugging.
- Do not use the machine for vacuuming any type of chemicals, acids, or solvents, as it will damage the machine.
- Do not use the product near explosive materials, inflammable liquids, or any type of gas, as it can cause fire or explosions.
- Keep the end of the hose, wands, and other openings away from your face and body.
- Use the machine only for the purpose described in this user’s guide.
- Using improper voltage may result in damage to the motor and possible injury to the user; the correct voltage is listed on the rating label.
- Do not disconnect the AC plug roughly; always pull out the plug by holding the plug itself.
- Do not connect or disconnect the AC plug with wet hands, as this may result in electrical shock.
- Always switch off your machine and disconnect the AC plug when the appliance is not in use.
- Do not use your machine if the AC cord or plug is damaged.
- If the cleaner is damaged, it must be repaired by the manufacturer its service agent, or a similarly qualified person to avoid hazards.
- This appliance is not intended for use by children or persons without assistance if their capabilities prevent safe use. Children should be supervised to ensure they do not play with the appliance.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent, or a similarly qualified person to avoid hazards.
- The vacuum cleaner must not be left unattended while connected to the mains.
- This vacuum cleaner is for household use only.
- Remove the plug from the socket outlet before cleaning or maintaining the vacuum cleaner.
Frequently Asked Questions
What are the technical specifications of the Tristar SZ-2174 Cyclone Vacuum Cleaner?
The vacuum cleaner operates on 220-240V~ 50/60Hz and has a power consumption of 800W. The model number is SZ-2174, and it is a bagless vacuum cleaner.
Can children operate the Tristar SZ-2174 Cyclone Vacuum Cleaner?
Children or unsuitable persons should not operate the vacuum cleaner. Always supervise children to ensure they do not play with the appliance.
What should I do if the power cord is damaged?
If the supply cord or plug is damaged, stop using the machine immediately and contact the manufacturer or its service agent for a replacement.
Where is the Tristar SZ-2174 Cyclone Vacuum Cleaner manufactured?
The vacuum cleaner is by Tristar Europe B.V., located in Tilburg, The Netherlands.
What is the batch number of my Tristar SZ-2174 Cyclone Vacuum Cleaner and why is it important?
The batch number for this model is T 14 7 65. It is crucial for identifying the specific production run of your vacuum cleaner and can be important for warranty claims, sourcing replacement parts, or receiving support.
Can I use the Tristar SZ-2174 Cyclone Vacuum Cleaner for wet surfaces?
No, it is not designed for wet surfaces. Operating the machine in excessively wet environments can damage the vacuum cleaner and pose safety risks.
How often should I clean or replace the HEPA filter?
The frequency of cleaning or replacing the HEPA filter can depend on usage. It's generally recommended to check and clean the filter regularly and replace it when it shows signs of wear or at least once a year for optimal performance.
Are there any specific storage instructions for the Tristar SZ-2174 Cyclone Vacuum Cleaner?
The vacuum cleaner should be stored in a dry, cool place out of reach of children. Ensure the cord is properly wrapped and that all accessories are stored securely to prevent damage.
Can I vacuum ash or construction dust with my Tristar vacuum cleaner?
No, vacuuming hot or burning objects like ash or harsh particles like construction dust can damage the internal components and filter of your vacuum cleaner.
What should I do if my vacuum cleaner overheats?
If your vacuum cleaner overheats, turn it off immediately and unplug it. Check for blockages in the nozzle, hose, or filters that might be causing the motor to work harder than normal. Allow the vacuum cleaner to cool down completely before attempting to use it again.
Can I use accessories or parts from other models or brands with my Tristar SZ-2174 Cyclone Vacuum Cleaner?
To avoid shortening the lifespan or damaging your product, use only the original spare parts or accessories recommended by the manufacturer.
Reference:Tristar SZ-2174 Cyclone Vacuum Cleaner User Manual- device.report
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>