Mmd Hong Kong Holding TAS7505 Portable Wireless Mono Speaker Instructions
- June 6, 2024
- Mmd Hong Kong Holding
Table of Contents
Mmd Hong Kong Holding TAS7505 Portable Wireless Mono Speaker
Important Safety Instructions
- ake sure that the power supply voltage corresponds to the voltage of the unit, there is a rating label on the back of the unit, it needs to open the net cover, the rating label is located on the lower center of the plastic cover.
- he speaker shall not be exposed to dripping or splashing.
- o not place any source of danger on the speaker (e.g. liquid filled objects, lit candles).
- ake sure that there is enough free space around the speaker for ventilation.
- Please use the speaker safely in an environment with temperature between 0° and 45°.
- – Only use attachments and accessories specified by the manufacturer.
Battery safety precaution
- anger of explosion if a battery is incorrectly replaced. Replace only with the same or equivalent type.
- battery (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
- battery in extreme high or low temperatures during use, storage or transportation, and low air pressure at high altitude can pose safety hazards.
- Do not replace a battery with an incorrect type that can defeat a safeguard (for example, some lithium battery types).
- Disposing a battery into fire or a hot oven mechanically crushing or cutting a battery can result in an explosion.
- Leaving a battery in an extremely high tempreature surrounding, or an extremely low air pressure environment may result in an explosion or leakage of flammable liquid or gas.
Warning
- Never remove the casing of this speaker.
- Never lubricate any part of this speaker.
- Place this speaker on a flat, hard and stable surface.
- Never place this speaker on other electrical equipment.
- Only use this speaker indoors. Keep this speaker away from water, moisture and liquid-filled objects.
- Keep this speaker away from direct sunlight, naked flames or heat.
- Risk of explosion if a battery is replaced by an incorrect type.
Notice
Hereby, TP Vision Europe B.V. declares that this speaker is in compliance with
the essential requirements and other relevant provisions of Directive
2014/53/EU. You can find the Declaration of Conformity on
www.philips.com/support. This speaker is
designed and manufactured with high quality materials and components, which
can be recycled and reused. When this crossed-out wheeled bin symbol is
attached to a product it means that the product is covered by the European
Directive 2012/19/EU. Please be informed about the local separate collection
system for electrical and electronic products. Please act according to your
local rules and do not dispose your old products with your normal household
waste. Correct disposal of your old products will help prevent potential
negative consequences for the environment and human health. Your speaker
contains batteries covered by the European Directive 2013/56/EU, which cannot
be disposed with normal household waste. Please be informed about the local
rules on separate collection of batteries because correct disposal will help
prevent
negative consequences for the environmental and human health.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and consider removing the no- collocation statement.
Canada Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to
the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the
packaging easy to separate into three materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags and protective foam sheet).
Your speaker consists of materials which can be recycled and reused if
disassembled by a specialized company. Please observe the local regulations
regarding disposal of packaging materials, exhausted batteries and old
equipment.
Specifications
General information
- Power requirementy ………………………………………………………………………………………………………………………… 5V 2A
- Lithium battery…………………………………………………………………………………………………………………..3.7V 7500mAh
- Dimensions (W x H x D) ………………………………………………………………………………………………………231x 87 x 85 mm
- Weight (Main Unit) …………………………………………………………………………………………………………………………….0.864kg
Amplifier
- Output Power …………………………………………………………………………………………………………………………………………. 30W
- Frequency Response ……………………………………………………………………………………………………………20 – 20000 Hz
- Signal to Noise Ratio …………………………………………………………………………………………………………………………. > 70 dB
Speakers
- Speaker Impedance ………………………………………………………………………………………………………………………………….. 3Ω
- Speaker Maximum Input Power …………………………………………………………………………………………………………… 30W
- Speaker Driver ……………………………………………………………………………………………………………………………… 50x 90mm
Bluetooth
- Bluetooth version ……………………………………………………………………………………………………………………………………….5.0
- Frequency range ………………………………………………………………………………………………………………. 2402 – 2480 MHz
- Maximum power transmitted …………………………………………………………………………………………………………..8±2dBm
- Maximum communication range …………………………………………………………………………………………….approx. 20m
- Compatible Bluetooth profiles ………………………………………………………………………………………………..A2DP,AVRCP
Note: Design and specifications are subject to change without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>