Jrl LED2020 Remote Control Instruction Manual
- June 6, 2024
- Jrl
Table of Contents
LED2020 Remote Control
Instruction Manual
Remote Operating Instructions
Remote Controller
RF Remote control, long-distance,mini size, wire connection is simple and
very easy to use;
- Functions Of Each Button:
- Usages:
ON/OFF| AUTO| SPEED UP| SPEED DOWN| MODE UP| MODE DOWN| BRIGHTNESS
UP| BRIGHTNESS
DOWN| MATCH| SETTING| RED| GREEN| BLUE| WHITE| YELLOW| CYAN| PURPLE
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---
| | | | | | | | | | | | | | | |
Model usage| Press the mode button to select the lighting movement model you
want. Currently LED has below 6 models:
1. Multi-colour lighting twinkle consistently 2. single color lighting
twinkle consistently (total 7 colors) 3. Mult-color light moves consistently
4. Single color light moves consistently (total 7 single colors) 5. Multi-
color lighting moves discontinuously 6. Single color lighting moves
discontinuously.
Speed usage| Continuously press the speed up or down button untill the speed
you want.
Matching| Continuously press the MATCH button 5 times until the LED
flashes in white quickly to match the Remote control with the receiving
controller. Pressing the MATCH button for 5 times till LED flash in white
slowly to un-match;
Reorder RGB| Differ from kinds of LED, The R G B keys may don’t perfectly
match your LED, Reorder them if needed. Continuously press the SETTING
button 5 times until the LED flash in white once and then turn into all-white,
Pressing the R button until LED is red, Pressing the G button until
LED is green, pressing the B button till LED is blue, then press the
SETTING button once to confirm your setting;
Receiving Controller:
Cautions: Please make sure the power supply voltage matches your controller before you power it. Warning
Warning
This product contains a Button battery. If swallowed, it could cause severe injury or death in just 2 hours. Seek medical attention immediately.
Always purchase the correct size and grade of battery most suitable for the
intended use. Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery
installation.
Ensure the batteries are installed correctly with regard to polarity (+and -).
Remove batteries from equipment that is not to be used for an extended period
of time.
Remove used batteries promptly.
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>