Shanghai Shengzhen Commercial Trade GDR-41 Remote Control Instructions
- June 6, 2024
- Shanghai Shengzhen Commercial Trade
Table of Contents
Commercial Trade GDR-41 Remote Control
Instruction Manual
Product name: Remote Control
Model: GDR-41
INSTRUCTIONS TO PROGRAM A REMOTE:
- Press and release the learn button on the back of the motor unit. The light will illuminate for 30 seconds. This indicates the unit is in programming mode.
- Within 15 seconds press the button you wish to program on the remote control.
- You will hear an audible click and/or the light on the motor unit will turn off indicating the remote successful programming.
*Repeat steps 1-3 for any additional remotes you wish to program. Wait 60 seconds before programming another remote control.
FCC Statement:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.