Shanghai Shengzhen Commercial Trade GDR-38 Remote Control Instructions
- June 6, 2024
- Shanghai Shengzhen Commercial Trade
Table of Contents
Shanghai Shengzhen Commercial Trade GDR-38 Remote
INSTRUCTIONS TO PROGRAM A REMOTE
- Product: Remote Control
- Model: GDR‐38
- Power: DC 3V (Lithium Cell CR2032) Hardware Version: V0
- Software Version: V0
- Frequency List: 315MHz
- Antenna Type: PCB Antenna Maximum Antenna Gain:0dBi
- Press and release the learn button on the back of the motor unit. The light will illuminate for 30 seconds. This indicates the unit is in programming mode.
- Within 15 seconds press the button you wish to program on the remote control.
- You will hear an audible click and/or the light on the motor unit will turn off indicating the remote successful programming.
Repeat steps 1‐3 for any additional remotes you wish to program. Wait 60 seconds before programming another remote control.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However,there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>