NITECORE NUOS Head Lamp Mate Instructions

: June 6, 2024
: Nitecore

Table of Contents

Features
Specification
Accessory
Brightness & Runtime
Operating Instruction
Warranty Service

NITECORE NUOS Head Lamp Mate

Features

Lightweight and tiny warning light
Utilizes 4 high performance LEDs
Dual white and red light sources
Built-in rechargeable Li-ion battery with max runtime up to 20 hours
Built-in intelligent Li-ion charging circuit for Micro-USB charging
Simple one switch control for one-handed operation
4 special modes selectable
Built-in power indicator to indicate remaining power level
Constructed from durable and sturdy PC material
Ultra-lightweight design for extreme portability
1 meter impact resistance

Specification

Size:	29.5mm×30.3mm×16.3mm (1.16”×1.19”×0.64”)
Weight:	10.4g (0.37oz)

Accessory

Simple edition:

No additional accessories

NU05 kit:

Headlamp band
USB cable
Bike mounts

Brightness & Runtime

| Red Indicator (slow blink)| Red (slow blink)| Red (quick blink)| White (slow blink)| White Light Illumination
---|---|---|---|---|---
Output| —| 4 lumens| 4 lumens| 35 lumens| 35 lumens
Runtime| 20h| 9h| 9h| 2h15min| 1h

1 meter (Impact resistance)

IP66 (Dustproof and waterproof)

NOTE: The stated data has been measured with NU05 built-in Liion battery (3.7V 120mAh). The data may vary during real-world use due to different environmental factors.

Operating Instruction

ON/OFF Turn on: Tap the switch once to turn on the NU05 and the red indicator will blink slowly. Turn off: If no further operation occurs 3 seconds after turning on, tap the switch once again to enter standby status. When the NU05 is fully charged, the max standby time up to 1 year theoretically.

Mode Selection

NU05 has 4 special modes and white light illumination. Within 3 seconds interval, press the switch repeatedly to cycle through Red Indicator (slow blink) – Red Light (slow blink) Red Light (quick blink) – White Light (slow blink) – White Light Illumination – Standby.

Lockout/unlock

Lockout: When the light is on, hold the switch for one second to lockout; after lockout, the indicator will blink once to notify user. Unlock: In lockout status, hold the switch for three seconds, the NU05 will unlock and then enter the Red Indicator (slow blink).

Charging

The NU05 has a USB charging port. As shown in the diagram, open the rubber cover of the USB port, plug the end of the USB cable into the port and the other end to the power source (adapter, computer or other power devices) to charge. It takes about 2 hours to fully charge NU05.
Power tip: A red indicator will turn on during charging. Upon completion red indicator light will turn green.

Power tips

In standby status, hold the switch for one second, the indicator will blink to indicate the power level: 3 blinks indicate the power level is above 50% 2 blinks indicate the power level is below 50% 1 blink indicates the power level is close to depletion
NOTE: When the power level is insufficient, the NU05 will dim and should be charged before further use.

Warranty Service

All NITECORE® products are warranted for quality. DOA/defective products can be exchanged for replacement through a local distributor/dealer within the 15 days of purchase. After 15 days, all defective / malfunctioning NITECORE® products will be repaired free of charge for a period of 24 months from the date of purchase. After 24 months, a limited warranty applies, covering the cost of labor and maintenance, but not the cost of accessories or replacement parts. The warranty is nullified in all of the following situations:

The product(s) is/are broken down, reconstructed and/or modified by unauthorized parties.
The product(s) is/are damaged through improper use.

※ For the latest information on NITECORE® products and services, please contact your national NITECORE® distributor or send an email to service@nitecore.com. The Nitecore official website shall prevail in case of any product data changes.

Worldwide Warranty Service

Model number —————————————
Date of purchase—————————————
Serial number—————————————
Store Stamp—————————————

This is the certificate of authenticity if this item and we confirm that it has been subjected to the most exacting quality controls by SYSMAX Innovations Co., Ltd.

NOTE:
Please ensure this warranty card is fully completed by the distributor or retailer after purchasing the product. Should the product fail to operate correctly during the warranty period, it may be returned with the completed warranty card and original sales receipt to the retailer or local distributor for replacement or repair.

Customer Service Email:service@nitecore.com

SYSMAX Innovations Co., Ltd.

TEL: +86-20-83862000
FAX: +86-20-83882723
E-mail:info@nitecore.com
Web:www.nitecore.com
Address： Rm 2601-06, Central Tower, No.5 Xiancun Road, Tianhe District, Guangzhou,510623, Guangdong, China