hama 179557 SAT Finder Instruction Manual
- June 6, 2024
- Hama
Table of Contents
hama 179557 SAT Finder Instruction Manual
Operating instruction
Safety instructions
- Protect the product from moisture.
- Do not leave the SAT finder permanently installed between the SAT dish and the receiver.
- Take proper safety precautions when working on the roof (risk of falling). If in doubt, contact a qualified technician and do not attempt to mount the product yourself!
Adjusting the SAT system for the best possible reception using the SAT
finder
- Disconnect the SAT receiver from the power supply and connect the SAT finder as shown with the short F cable (not included) between the LNB and receiver.
- Reconnect the receiver to the power supply, select a channel.
- Using a protractor and compass, roughly adjust the SAT antenna (SAT dish) according to the desired satellites. Search for the proper satellite by turning and panning the SAT antenna.
- If the LEDs give a full reading (2), turn the sensitivity adjuster (1) in the anti-clockwise direction until only 2 to 3 LEDs light up.
- Now finely tune the antenna until as many red LEDs (2) light up as possible
- The “22 kHz” LED (3) lights up when the 22 kHz signal is transmitted.
- Tighten the antenna fasteners.
- WARNING: The set value can change again when the screws are tightened.
- On your receiver, check if the desired satellite can now be received.
- You can now remove the SAT finder and reconnect the LNB and the receiver
Hama GmbH & Co KG
86652 Monheim/ Germany
Service & Support
+49 9091 502-0
All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>