MARQUANT 004954 Clock Radio Wake Up Light Instruction Manual

MARQUANT 004954 Clock Radio Wake Up Light

SAFETY INSTRUCTIONS

•  Check that the mains voltage corresponds to the rated voltage.
•  Do not expose the product to rain or moisture – the risk of fire and/or electric shock.
•  Never open the casing – risk of electric shock. Service must only be carried out by qualified personnel.
•  Do not expose the product to extreme temperatures or high relative humidity to ensure normal functionality and a long life span.
•  Do not put the product in a bathroom, or near a cooker or heater.
•  If the product is not working properly, take it to the nearest service center. Do not attempt to repair it yourself.
•  Only use the supplied mains adapter.
•  This product is not intended to be used by persons (including children) with functional disorders, or by persons who are not familiar with how the product is used unless they are supervised or receive instructions concerning its use from someone who is responsible for their safety.
• Keep children under supervision to make sure they do not play with the product.

TECHNICAL DATA

• Rated voltage                230 V ~ 50 Hz
• Batteries                      3xAAA
• Diameter                      r/J 170 mm
• Depth                         105 mm
• Cord length                1.2 m

DESCRIPTION

FRONT

• Illumination
• Time
•  @ Snooze function
•  ® Actual time
• @Alarm
• reduce
• @Light
• 0 Increase
•  ©sunset
•  @ FM radio

BACK

•  @volume

•  @ Natural sound

•  8 Selection of 12 or 24-hour display

•  @ Brightness of time display

•  USB port
•  Battery compartment
•  Battery positioning

USB

• To start, connect the USB cable to the mains adapter and clock radio. Plug the mains adapter into a power point.
• The clock radio has reserve batteries that save the settings in the event of a power cut.

INSERTING THE BATTERIES

• Open the battery compartment.
•  Insert 3 AAA batteries with the correct polarity (sold separately).
•  Replace the battery compartment cover.

NOTE

•  The functionality of the clock radio is limited when running on the batteries.
•  The alarm function and radio can be used.
•  The light functions cannot be used when running on the batteries.
•  Remove the batteries if the clock radio is not going to be used for some time.
•  If the reserve batteries become discharged the clock radio will switch off and the settings will be lost.

SETTING THE TIME

The digits start flashing when the mains adapter is plugged in.

Setting the hour

•  Set the hour with the buttons G) and
• Press the button® to confirm.

Setting the minutes

•  Set the minutes with the buttons G) and
•  Press the button ®to confirm. Press the button® again if the digits start flashing.

Selection of 12 or 24-hour display

• Press button 8 to switch between 12 and 24-hour displays.

NOTE:
The 12-hour display shows AM or PM

BRIGHTNESS

Press the button ®to set the display brightness:

•  Low
•  High
•  Off

FM RADIO

•  Press the button Sto start/switch off the FM radio.
•  Press the button Stor 3 seconds to start automatic station search. Searching takes place automatically and available FM stations are stored.
•  Press the buttons G) orGto select an FM station.
•  Press the button ®to set the volume 1-15.

NOTE:
The time is not shown when the radio is on.

SETTING THE ALARM

•  Press the button ®to to enable/disable alarm mode. The symbol◊/· goes on/off on the display.
•  Press the button ®to enable alarm setting mode. The digits for the hour flash.

Setting the hour

•  Set the hour with the buttons G) and 8.
•  Press the button ®to confirm.

Setting the minutes

•  Set the minutes with the buttons(±) and 8.
•  Press the button ®to confirm.
• Press the button@ again if the digits stop flashing.

Natural sound

• Press the button ®to to choose the alarm signal.

• Choose sound 1-7 with(±) or 8.

• Press the button® to confirm. Sounds 1-6 play for 5 seconds when chosen.
  If 7 is chosen, the last selected radio station will play as the alarm signal.

• 4. Press the button @to set the volume 00- 15.

SIMULATION OF SUNRISE

The waking light goes on with low intensity 30 minutes before the set alarm, after which the brightness gradually increases to full intensity at the set alarm. The set natural sound or radio plays for 2 minutes.

When the alarm signal goes on

•  Press the button @to switch off the alarm for 5 minutes. After 5 minutes the alarm goes on again for 2 minutes.
• Press any button except@to switch off the alarm.
• Press the button® to switch off the waking light.

Setting the time for simulated sunset

• Press the button ©to enable/disable sunset mode. The symbol goes on/off on the display.
• Press the button ©to enable settings mode. The digits for the hour flash.

Setting the hour

• Set the hour with the buttons(±) or 8.
•  Press the button ©to confirm.

Setting the minutes

•  Set the minutes with the buttons(±) or B.
•  Press the button ©to confirm.

LIGHT

• Press the button ®to switch on the light.
•  Set the brightness (1-10) with the buttons (±)or 8.
•  Press® again to enable automatic colour changing.
• Use(±) or 8 to choose green, red, blue, violet, orange, indigo.
•  Press the button® a third time to switch off the light.

SIMULATION OF SUNSET

• 30 minutes before the set time for sunset the light goes on at full intensity, after which the brightness is gradually reduced until the light goes off at the set time.
• The light can be switched off at any time duriQ-(l_ the simulated sunset by pressing the® button.

IMPORTANT:

•  Do not press two or more buttons at the same time.
•  Wait at least 1 second before pressing the next button, otherwise, there is a risk of malfunctioning.
•  In the event of a malfunction, pull out the mains adapter, wait 3 seconds, and con the mains adapter again.
•  The time display goes off automatically after 15 minutes. Press any button to show the time.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>