MARQUANT 889005 Nose and Ear Hair Trimmer Instruction Manual
- June 4, 2024
- MARQUANT
Table of Contents
MARQUANT 889005 Nose and Ear Hair Trimmer
SAFETY INSTRUCTIONS
Read these instructions carefully before use!
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.
- Keep the appliance and its cord out of reach of children less than 8 years.
- This personal grooming product is intended for trimming nose and ear hair. Do not use it for any other purpose.
- Do not insert the trimmer further than the length of the trimmer tip into your nostrils or ears.
- Do not apply any pressure against your ears or nostrils while using the trimmer.
- Do not use the trimmer if the casing or any blade is deformed or damaged. This can cause injuries in your nose and ears.
- The blade is precision-made and must not be exposed to knocks or blows.
- If the nose and ear trimmer is used once a week for approximately one minute, the blade has a lifetime of approximately four years.
TECHNICAL DATA
- Operating voltage 1 x 1.5 volt AAR6 battery
- Power consumption 0.8 W
- Safety class III
DESCRIPTION
- Trimmer
- Power switch
- Battery compartment cover
OPERATION
Pull off the battery compartment cover at the bottom and insert one 1.5 volt AAR6 battery. Turn on the power switch and carefully insert the trimmer tip into your nostrils and ears to remove unwanted hair growth.
MAINTENANCE
Turn off the appliance before cleaning or replacing the trimming blade. In order to remove the casing, turn the casing so that the markings are directly opposite each other and pull up. Disconnect the inner blade from the outer blade and clean the blade of loose hair, dust, etc., using the cleaning brush and possibly a small cloth. Refit the inner blade in the outer blade. Refit the casing so that the markings are directly opposite each other, and turn clockwise until the casing clicks into place.