Speed Queen DR3 Dryer User Manual
- June 6, 2024
- Speed Queen
Table of Contents
Speed Queen DR3 Dryer
Welcome
Welcome to the Speed Queen® family. Thank you for your support of our truly
commercial quality products. Our washers and dryers are expertly engineered to
deliver commercial performance, tested to ensure ultimate durability and built
with American Pride. For more than 110 years, Speed Queen consumer laundry
products have been manufactured in Ripon, Wisconsin, a place where pride of
workmanship is not just alive, but thriving and embodied by each individual
who designs, tests, assembles or in some way touches a Speed Queen product. A
special thing happens when that pride is combined with the highest quality
commercial materials and components…it leads to the ultimate
reliability…reliability measured in decades, not years. That’s legendary Speed
Queen Quality.
Installation
Parts included:
-
Position and level the dryer.
- Recommended rear clearance minimum is 2 in (51 mm) for utility connections and 6 in (152 mm) when venting through rear of unit
-
Connect exhaust system.
- Dryer must be exhausted to the outdoors
- Use 4 in (102 mm) rigid duct
- Maximum straight duct length = 65 ft (19.8 m). Each elbow deduct 10 ft (3 m)
- Sufficient make-up air must be sup-plied. The free area of any opening for outside air must be at least 40 in2 (25806 mm2) per unit
-
Gas models – connect gas supply pipe. Gas service to a gas dryer must conform with the local codes and ordinances. Refer to installation instructions, which can be found at
speedqueendoc.net- Tighten all connections securely but do not overtighten to avoid breaking or bending the gas valve bracket.
- Turn on gas and check all pipe connections (internal and external) for gas leaks by applying a non-corrosive leak detection fluid to the fittings. If bubbles are present then a leak is likely.
Retighten connections and recheck for leaks.
-
Electric models – connect electrical cord with three-wire or four-wire plug. Refer to installation instructions, which can be found at speedqueendoc.net
-
Wipe out inside of dryer.
-
Plug in the dryer.
-
Start dryer and check that dryer is heating.
Operating
Register
-
Register your product at www.speedqueen.com to take full advantage of the limited warranty.
3, 5 & 7 Year Warranties, depending on your model. Covers all parts and in- home labor.
Warranty
Note: This unit includes a limited warranty. Refer to Speedqueendoc.net to download the full warranty bond. -
Download full documentation and view installation and operating videos for an immersive experience at Speedqueendoc.net or scan the QR code below.
-
If you wish to receive printed documents at no cost, please complete the order form online at speedqueen.com/request-printed-documents/or email your request to technicalcommunications@alliancels.com.
Order Form for Printed Documentation
- Please send me a printed Installation Manual, User’s Guide, and Warranty Bond.
- I understand this card does not register my product. I must go to www.speedqueen.com to register.
SPEED QUEEN
TECHNICAL DOCUMENTATION SHEPARD STREET
P O BOX 990
RIPON WI 54971-9967
Part No. D518607
February 2021
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Speed Queen by Alliance Laundry Systems
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>