MOBILOGIX ATD700S Low-Power M1 Agricultural Tank Sensor Tracker User Guide

: June 6, 2024
: Mobilogix

Table of Contents

INTRODUCTION
CONTACTS
DISCLAIMERS
VERSION HISTORY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ATD700S Low-Power M1 Agricultural
Tank Sensor Tracker
User Guide

INTRODUCTION

The ATD700S is a solar-powered LTE CAT-M1, IP67 rated mobile asset tracking device with an onboard radar sensor for monitoring fill level tanks in agriculture.
ATD700S is affixed to the top of a tank and will use radar to measure the fluid level. Tank location will be obtained using GNSS. After measuring the fluid level and location the data will be sent to a cloud server using a cellular air interface connection.

CONTACTS

DISCLAIMERS

FCC INTERFERENCE STATEMENT (PART 15.105 (B))
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

FCC PART 15 CLAUSE 15.2 1
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC PART 15.19(A) [INTERFERENCE COMPLIANCE STATEMENT]
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

ISED RSS-GEN NOTICE

This device complies with Industry Canada’s license-exempt RSS. Operation is subject to the following two conditions:

This device may not cause interference; and
This device must accept any interference, including interference that may cause undesired operation of the device.

FCC RF EXPOSURE GUIDANCE STATEMENT
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times.

ISED RF EXPOSURE GUIDANCE STATEMENT
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times.