Shenzhen Daping Computer DP-RW01 433 Buzzer Water Sensor Instructions
- June 6, 2024
- Shenzhen Daping Computer
Table of Contents
Shenzhen Daping Computer DP-RW01 433 Buzzer Water Sensor
At a glance
Specification
Power supply voltage:
| AAA*2 section DC3V (capacity 1000mAh)
---|---
Working current:
| <90mA
Quiescent Current:
| <13µA
DecibeL
| >120dBA
Working frequency:
| ****
433.9845MHz
Size:
| ****
110mm45mm27mm
Code sending:
| (D0\D1\D2}
Installing your Device
- Rull out the battery Insulation sheet;
- Placement.
Using your device
- Detecting dripping
- Removing the alarm please dry the sensor first and then the alarm would be removed
- low battery alarm
when the power com pacify is less the 50%
didi
When you feel noisy, click the button to turn off the sound
warning: Do not put the product In water
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>