AEG VX7 X Power Vacuum Cleaner Instructions

AEG VX7 X Power Vacuum Cleaner Instructions

BEFORE STARTING

Read this manual carefully.
Check that all parts described are included. Pay special attention to the safety precautions.

DESCRIPTION OF VX7 VACUUM CLEANER

• A. Display with rotary knob manual control
• B. Exhaust filter
• C. Parking slots
• D. Power cord
• E. Motor filter
• F. Motor filter holder
• G. S-bag
• H. S-bag holder
• I. Dust compartment cover
• J. 3in1 tool
• K. Hose
• L. Handle
• M. Telescopic tube
• N. Parking clip
• O. Flow Motion nozzle
• P. Upholstery nozzle*
• Q. Turbo nozzle*
• R. Mini turbo nozzle*
• S. ParkettoPro nozzle*
• Certain models only.

Safety requirement and warning

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
WARNING: Turbo nozzles* have a rotating brush in which parts may become entrapped. Please use them with caution and only on intended
surfaces. Please turn the vacuum cleaner off before removing entrapped parts or cleaning the brush. The Turbo nozzle is not suitable for carpets
with deep piles and long fringes, anti-slip carpets like door mats or water resistant carpets.
Children should be supervised to ensure that they do not play with the appliance.
Cleaning and maintenance shall not be made by children without supervision.
Always disconnect the plug from the mains before cleaning or maintaining the appliance.
Never use the vacuum cleaner without its filters.
Always use original s-bag dust bags suitable for this particular vacuum cleaner. Damages caused to the cleaner by incorrect use of none-original dust bags is not covered by the warranty.

Caution
This appliance contains electrical connections:

• Never vacuum any liquid
• Do not immerse in any liquid for cleaning
• The hose should be checked regularly and must not be used if damaged.
  The above can cause serious damage to the motor, which is not covered by the warranty. This vacuum cleaner is for domestic use only.

Never use vacuum cleaner

• Close to flammable gases, etc.
• On sharp objects
• On hot or cold cinders, lit cigarette butts, etc.
• On fi ne dust, for instance plaster, concrete, flour.

Power cord precautions

• Never use the vacuum cleaner if the cord is damaged.
• If the cord is damaged, it must be replaced only by an authorized AEG service center in order to avoid a hazard. Damage to the vacuum cleaner’s cord is not covered by the warranty.
• Never pull or lift the vacuum cleaner by the cord. All servicing and repairs must be performed by an authorized AEG service center. Store the vacuum cleaner in a dry place.

Consumer information and sustainability policy

AEG declines all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. For more details of warranty and consumers’ contacts see the Warranty Booklet in the packaging.
If you have any comments on the cleaner or the Operating Instructions manual please e-mail us at floorcare@aeg-home.com.

Sustainability policy

This product is designed with the environment in mind. All plastic parts are marked for recycling purposes.

For details see our website: www.aeg-home.com.

The packaging material is chosen to be environmentally friendly and can be recycled.

Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.

HOW TO USE THE VACUUM CLEANER

Open the dust compartment cover. Check that the dust bag (s-bag) is in place.

Insert the hose into the cleaner (to remove it, press the lock buttons and pull). Insert the hose into the hose handle until the lock button clicks (to release it, press the lock button and pull).

Attach the telescopic tube to the nozzle. Attach the telescopic tube to the hose handle (to remove it, press the lock button and pull). Adjust the telescopic tube by holding the lock with one hand and pulling the handle with the other hand.

START/STOP THE VACUUM CLEANER AND ADJUST SUCTION POWER

Pull out the power cord and plug it into the mains. Press the ON/OFF button to turn the cleaner on/off.

Adjust suction power. Turn the rotary knob on the cleaner or use the air valve on the handle.

After cleaning, push the REWIND button to rewind the cable.

PARKING POSITIONS

Use parking position underneath (A) to carry and store the cleaner. At the back (B) when you pause (save your back).

REPLACING THE DUSTBAG, S-BAG®

Replace the s-bag when

S-BAG indicator lights up in red NB:

Always change the s-bag when S-BAG indicator is illuminated even if the s-bag is not full (it may be blocked) and after using carpet cleaning powder. For best possible performance, use the Ultra Long Performance bag which is especially developed for your cleaner. Other synthetic s-bags can also be used. Do not use paper dust bags! www.s-bag.com.

Pushing and lifting the OPEN button to open the dust compartment. Lift the handle to remove the s-bag with holder.

A. Pull the cardboard to remove the s-bag® from the insert. This automatically seals the s-bag® and prevents dust leaking out. B. Insert a new s-bag® by pushing the cardboard right into the end of the groove in the insert.

Close the lid. If the s-bag is not properly placed or is missing, the lid will not close.

REPLACING THE FILTERS

Replace/clean the exhaust filter at every fifth replacement of the dust bag (s-bag®). Use AEG original filters: (AEF12W, AFS1W) / AEFG12W. Lift out the filter and check the color of the frame: Green: Must be replaced by a new filter (non-washable filter). Blue: Replace with a new filter or clean it.

Rinse the inside (dirty side) in lukewarm tap water. Tap the filter frame to remove the water. Repeat the process four times. (washable filter only)
NB:** Do not use cleaning agents. Avoid touching the filter surface. Let the filter dry completely (min. 24 h in room temperature) before putting back! Change the washable filter at least once a year or when it is very dirty or damaged. After replacing the filter, close the dust compartment lid until it is clicked back into place.

Replace the motor filter (AF08) when dirty or after every 5th s-bag. Push the filter holder down and pull it out. Exchange the filter and close the lid.

VACUUMING WITH THE UNIVERSAL NOZZLE

Change nozzle setting with the pedal. Icon illustrates recommended floor type.

CLEANING THE UNIVERSAL NOZZLE

Disconnect the nozzle from the tube. Clean with the hose handle.

CLEANING THE TURBO NOZZLE

Disconnect the nozzle from the tube and remove entangled threads etc. by snipping them away with scissors. Use the hose handle to clean the nozzle.

TIPS ON HOW TO GET THE BEST RESULTS

*3in1 accessory tool

**

| 3 tools in 1:

1. Dusting tool for hard surfaces (bookshelves, skirting boards etc).
2. Upholstery tool for textiles (curtains, upholstery etc).
3. Crevice tool for narrow spaces (behind radiators etc).

Turbo *nozzle

**

| Carpet nozzle:

• Brushes and vacuums at the same time (best pick up of hair, fibres etc).
• Brush roller is driven by the airflow of the vacuum cleaner.
• Not suitable for carpets with very deep piles and long fringes, anti-slip carpets like door mats or water resistant carpets. Use universal nozzle instead.

*Parketto Pro nozzle

**

| Hard floor nozzle:

• For gentle cleaning of hard floor (parquet, wooden floor, tiles etc).
• Best dust pick up on hard floor with crevice.

*Precision Flow nozzle

**

| Universal nozzle:

• For all floor types, secures best dust pick up on both carpets and hard floors.
• Change nozzle setting with the pedal. Icon will show recommended floor type.

*Mini Turbo nozzle

**

| Mini turbo nozzle:

• Brushes and vacuums at the same time.
• For textile furniture, car seats, mattresses etc.
• Brush roller is driven by the airflow of the vacuum cleaner.
• Not suitable for carpets with very deep pile and long fringes as it can get stuck in the rotating brush roll.

*Upholstery nozzle

**

| Upholstery nozzle:
Use the upholstery nozzle for sofas, curtains, lightweight fabrics etc. Reduce suction power if necessary.
Models with manual power regulation – follow graphics on cleaner for optimal performance.

TROUBLESHOOTING

PROBLEM

|

SOLUTION

---|---
The vacuum cleaner does not start|

• Check that the cable is connected to the mains.
• Check that the plug and cable are not damaged.
• Check for a blown fuse.

The s-bag® indicator light is illuminated|

• Check if the s-bag® is full or blocked.
• If you have already changed the s-bag®, change the motor filter.

The cleaner stops| The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube, hose or filters are blocked. Let the cleaner cool down for 30 minutes before plugging it in again.
If the cleaner still does not work, contact an authorized AEG service center.
Reduction of suction capacity versus normal|

• Check if the s-bag is full or blocked.
• Check if the motor filter is clogged and needs changing.
• Check if nozzle is blocked and needs to be cleared.
• Check if hose is blocked by squeezing it gently. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose.
  Note: The warranty does not cover any damage to the hose caused by cleaning it.

Water has been sucked into the vacuum cleaner| It will be necessary to replace the motor at an authorized AEG service center.
Damage to the motor caused by the penetration of water is not covered by the warranty.
For any further problems, contact an authorized AEG service center.

References

• Welcome to AEG
• s-bag® the original dust bag | s-bag®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>