xiaomi M365PRO Electric Scooter User Manual
- June 6, 2024
- Xiaomi
Table of Contents
xiaomi M365PRO Electric Scooter
HOW TO USE
The control system contains two circuit boards, one is the motor control board
and the other is the Bluetooth dashboard that are connected through the UART
bus. Click the button on the Bluetooth dashboard, the system is turned on, and
the Bluetooth SOC NRF51802 collects the signals of the throttle Hall sensor
and brake sensor and sends them to the motor control board MCU LKS32MC061 C6T8
to control the motor operation through UART.
The control system is composed of other 5 components:
- The Beep is used to receive any alarm by the motor control board ;
- The Headlight is used to light up at night;
- The led light strip, Lighting when it is enabled;
- The Digital Tube is used to display the speed and how much power the battery has.
- The Led tail light Board, emit red light, is used to brake alarming.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>