dish 52.0 Remote Control User Guide
- June 6, 2024
- Dish
Table of Contents
Remote Control
Model 52.0
Quick Start Guide
Turn On Your Remote
1 Remove the back cover by pushing the tab upward, and remove the PULL tab
2 Replace the back cover
3 Open the front panel of your DISH receiver, and press the SYS INFO button
4 Press the SAT button on the side of the remote control
You will hear three beeps from the remcte control, indicating it has paired
with your DISH receiver
Pair Your Remote
1 Press the home button twice
2 Select Settings and then Remote Control
3 Select TV and then TV Pairing Wizard
4 Follow the prompts
5 If desied, pair your remote with an auxiliary device such as a Blu-ray'”
player or stereo
Explore Your Remote
Locate Your Remote Anytime
1 Open the front panel of your DISH receiver
2 Press the LOCATE REMOTE buttor
You will hear a series of beeps from your remote, allowing you to find it
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>