UGEE S1060W S Series Pen Wireless Graphic Drawing Tablet User Guide
- June 6, 2024
- UGEE
Table of Contents
UGEE S1060W S Series Pen Wireless Graphic Drawing Tablet
UGEE S Series Pen Tablet Quick Guide
Overview
-
Active area
-
Shortcut keys
-
Power key (Wireless models only)
-
Status shown by the white indicator:
-
Flashing: Stylus in the active area but not touching the pen tablet
-
Solid: Stylus in the active area for normal use
-
No light: Stylus outside the active area
-
USB-C port
-
Wireless+Power indicator (Wireless models only)
Status shown by the blue indicator: -
Flashing: The pen tablet is waiting for pairing and wireless connection
-
Solid: The pen tablet is successfully paired and connected
Status shown by the red indicator: -
Flashing: 20% battery remaining
-
Solid: The battery is being charged
-
No light: The battery is fully charged
-
Lanyard hole
-
Pen sleeve
**Accessories
**
Connection
Wired connection of the pen tablet
Connect the pen tablet to your computer, and make sure you can use the stylus
to control the cursor.
Wireless connection of the pen tablet (Only available on wireless pen
tablet)
- Plug the wireless receiver into the computer.
- Press and hold the power key on the pen tablet for 3 seconds to turn it on; it will be automatically connected to your computer, and then you can control the cursor with the stylus.
- Press and hold the power key on the pen tablet for 3 seconds to turn it off.
Download and install the driver on your computer to ensure that the product runs properly.
- Make sure your pen tablet was connected well to the computer
- Visit the UGEE website (www.ugee.com), choose Support section and click Download. Choose product model and download the latest driver according to your computer system.
- Follow the prompts to finish the driver installation.
Note:
For the best performance of your device, we highly recommend you review and
update the driver regularly from the UGEE website.
FCC regulatory conformance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
RF Exposure This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>