integratech UNIDRIVER36 Unidriver Met Amplitude Dimming Instruction Manual

June 6, 2024
integratech

integratech UNIDRIVER36 Unidriver Met Amplitude Dimming

Important
: Read All Instructions Prior to Installation

Function introduction

integratech-UNIDRIVER36-Unidriver-Met-Amplitude-
Dimming-2

  • Dimmable LED driver with DALI/Push/Triac/1-10V dimming interfaces
  • In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2.
  •  Built-in DALI-2 interface, DALI DT6 device
  • 1 channel constant current output, max. output power 38W
  • Output current 350-1000mA selectable by DIP switch
  • Enables to control single color LED lighting
  • Class Ⅱ power supply, full isolated plastic case
  • High power factor and efficiency
  • Compatible with universal DALI masters that support DT6 commands
  • Compatible with universal Triac dimmers
  • Compatible with universal 0/1-10V dimmers
  • Amplitude dimming (PWM dimming under 10%), deep and smooth dimming to 0.1%, flicker free
  • IP20 rating, suitable for indoor LED lighting applications
  • 5 years warranty

Dips to set the operation currentintegratech-UNIDRIVER36-Unidriver-Met-
Amplitude-Dimming-2

!! Always switch off the power before changing the dip switches !!

Settings for Integratech QT/QTU/BRIGHT panel series

  • 30W:750mA
  • 36W:900mA

Settings for Integratech MANGA U panel series

  • 30W:750mA
  • 36W:900mA
  • 38W:1000mA
    Toolless connection range: 0,75~2,5 mm²

Product Data

Output

| LED Channel| 1
---|---|---
Selectable Current| 350mA| 400mA| 450mA| 500mA| 550mA| 600mA| 650mA
DC Voltage Range| 8-57V| 8-57V| 8-57V| 8-57V| 8-57V| 8-57V| 8-57V
Selectable Current| 700mA| 750mA| 800mA| 850mA| 900mA| 950mA| 1000mA
DC Voltage Range| 8-54V| 8-50V| 8-47V| 8-44V| 8-42V| 8-40V| 8-38V
Current Accuracy| ±3%
Rated Power| 5-38W

Input

| Voltage Range| 220-240V AC
Frequency| 50/60Hz
Power Factor (Typ.)| >0.95
Efficiency (Typ.)| > 85% @ 230VAC
Input Current| 210mA @ 230VAC
Inrush Current (Typ.)| COLD START Max. 2A @ 230VAC

Control

| Dimming Interface| DALI (DALI consumption<2mA)/Push+Triac+0/1-10V
Dimming Range| 0.1%-100%
Dimming Method| Amplitude dimming (PWM dimming under 10%)

Protection

| Short Circuit| Yes, auto recovery after fault removed
Over Current| Yes, auto recovery after fault removed
Over Temperature| Yes, auto recovery after fault removed

Environment

| Working Temp.| -20℃ ~ +45℃
---|---|---
Max. Case Temp.| 85℃ (Ta=45℃)
Working Humidity| 10% ~ 95% RH non-condensing
Storage Temp. & Humidity| -40℃ ~ +80℃, 10% ~ 95% RH

Safety&EMC

| Safety Standards| EN61347-1, EN61347-2-13
Withstand Voltage| I/P-O/P: 3.75KVAC
EMC Emission| EN55015, EN61000-3-2, EN61000-3-3
EMC Immunity| EN61547, EN61000-4-2,3,4,5,6,8,11, surge immunity Line-Line 1KV

Others

|

MTBF

| 188600H, MIL-HDBK-217F @ 230VAC at full load and 25℃ ambient temperature
Dimension| 1705929mm (LWH)

Operation

Dimming Interface Selection

  1. The LED driver supports 4 kinds of dimming input: DALI, Push, Triac, 0/1-10V.
  2. Please select any of the 4 dimming interfaces to wire each time.
  3. To connect a new dimming interface, previously connected dimming interface must be disconnected.
  4. DO NOT connect more than 2 (including 2) dimming interfaces simultaneously.

DALI Address Assigned by DALI Masters
While connected with DALI interface, 1 DALI address can be assigned by DALI Master controller automatically, please refer to user manuals of compatible DALI Masters for specific operations.

PUSH Dimmer Mode
While connected with a AC PUSH, the driver will be in Push Dimmer Mode, operations under Push Dimmer Mode are as follows:

  1. Click the button to switch ON/OFF
  2. Press and hold down the button to increase or decrease light intensity to desired level and release it, then repeat the operation to adjust light intensity to opposite direction. The dimming range is from 1% to 100%.
  3. Memory function after power off or power failure enables the device to memorize the status before power off while power on again.

Triac Dimming Input
While connected with a Triac dimmer, different Triac dimmers from different suppliers may have different minimum dimming levels which the driver can not be dimmed below. To dim to 1%, please make sure the dimmer supports 1% minimum dimming level.

Wiring Diagram

With DALI bus L Nintegratech-UNIDRIVER36-Unidriver-Met-Amplitude-
Dimming-3

With Triac dimmerintegratech-UNIDRIVER36-Unidriver-Met-Amplitude-
Dimming-14

Product Dimension

Documents / Resources

| integratech UNIDRIVER36 Unidriver Met Amplitude Dimming [pdf] Instruction Manual
UNIDRIVER36, Integratech Unidriver Met Amplitude Dimming, UNIDRIVER36 Integratech Unidriver Met Amplitude Dimming, Met Amplitude Dimming, Amplitude Dimming, Dimming
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals