integratech EVOLVE2 LED Floodlight User Manual

Table of Contents

Open the packaging and check the product. In case of damage, contact your distributor immediately.
Disassemble the bracket or place it in the desired position. The unit can be easily aimed thanks to the degree indicator on the unit and the toolless adjustment screws.
Take into account the weight of the device. Preferably use solid wood threaded bolts, e.g. 80x6mm and 8mm plugs.
Always use two bolts per unit!

Electrical connection:

The unit is supplied with one pre-assembled M20 cable gland.
When using through-wiring, the M20 locking plug can be replaced by an additional M20 cable gland. (Order reference: EV2M20)
Unscrew the two screws to open the connection box.
Connection voltage 100~240VAC 50/60Hz.
Connection: brown=phase blue=neutral
Yellow/green= earth connection

on the circuit breaker

P| Type C| Type D
12/25W| 40| 70
45W| 30| 60
75W| 4| 7
100W| 7| 11
150W| 7| 11
200W| 3| 5
240W| 1| 2

Mounting possibilities:

The Evolve2 floodlight is suitable for placement on horizontal or vertical surfaces. The mounting height depends on the area you want to illuminate and the power of your projector.
Various mounting accessories are available: wall bar, ground pin, pole attachment, louvre.
Installation and maintenance must be performed by professionals only.
The light source of this luminaire is not replaceable; when it reaches its end of life the whole luminaire shall be replaced.
Damaged luminaires in original and unopened packing are exchanged under warranty.
For outdoor applications, always use strong stainless steel studs and ensure firm anchoring.
The ground wire must be well connected to prevent safety problems.
Always check if the appropriate connection voltage is present.

Utilization of used lamps

LED lamps must be disposed of in accordance with current regulations concerning environmental protection. Used lamps should be returned to the applicable collection point, where they will be accepted free of charge. Proper utilization of equipment enables preserving valuable environmental resources and avoiding adverse impacts on health and the environment, which may be threatened by inappropriate waste handling.

integratech-EVOLVE2-LED-Floodlight-FIG-4

Volgens de ecodesign richtlijn 2009/125/EG is dit verlichtingsarmatuur niet onderworpen aan een energielabel.
Ga voor informatie over de productprestaties naar https://www.integratech.be
Selon la directive 2009/125/CE dite écoconception, ce luminaire n’est pas soumis à l’obligation d’étiquetage énergétique.
Retrouvez la performance porduit en téléchargeant la fiche technique sur le site https://www.integratech.be
According to the Ecodesign Directive 2009/125/EC, this lighting fixture is not subject to energy labeling.
For information about product performance, please visit https://www.integratech.be
Integratech bvba – Groenstraat 48 – BE3270 Scherpenheuvel – Belgium