HEMA 80.03.0038 Electric Over Blanket Instruction Manual
- June 6, 2024
- Hema
Table of Contents
HEMA 80.03.0038 Electric Over Blanket
Technical specifications
Supply voltage: 220-240 V – 50Hz
Power consumption: 120 watt
Type: TSK160x130-1SC
2 year full HEMA warranty
- 1 person blanket
- 100% polyester
- 160 x 130 cm
- Can be washed at max. 40°C
Replace an electric blanket after about 10 years or earlier if the
condition of the electric blanket warrants it.
Components
Temperature settings: L (lowest) 1 2 3 4 5 6 7 H (highest)
Timer settings: 1 2 3 4 5 6 7 8 9 (hours)
A. Power switch
B. Digital display
C. Temperature button
D. Timer button
E. The highest temperature button
F . Connection of the cord to the blanket
G. Connection of the blanket to the cord
Blanket 160 x 130 cm washable after first detaching the cord
Precautions and Safety Instructions
Important instructions. Read the instructions carefully before use and retain instructions for future reference.
-
Used as over blanket.
-
Never use the electric over-blanket when folded, creased, folded back and/or tucked in. -
Make sure that there are no sharp creases, folds or pressure points and regularly recheck for these.
-
The blanket must only be operated using the supplied cord set with switch.
-
To prevent damage, do not insert pins or other sharp (metal) parts in the electric over-blanket. -
Do not place stacks of laundry, pillows or similar items on the electric over-blanket when it is switched on.
-
Do not tuck the blanket in.
-
The supply cord must not lie on or under the over-blanket.
-
Switch off the electric over-blanket every morning.
-
Do not use the electric over-blanket if it is wet or damp.
-
Do not expose the product to rain or moisture.
-
Do not use the product during a thunderstorm.
-
The electric over-blanket must not be dry-cleaned.
-
Only wash the electric over-blanket as indicated in the instructions.
-
The electric over-blanket must not be used for children, infirm or heat-insensitive persons.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-
The blanket should not be used by people with pacemakers, implants, or any other medical aid. Consult your doctor first.
-
Only use the electric over-blanket in conjunction with the supplied cord.
-
Make sure you remove the cord before washing the electric over-blanket as indicated in the instructions.
-
Remove the plug from the mains socket when the electric blanket is not in use.
-
Never remove the plug from the socket by pulling the cord; always remove by the plug.
-
Do not touch a blanket that has fallen into water. Unplug the product from the mains socket.
-
Electric blankets are intended for human use only, not for animals.
-
This product is not a toy. Do not allow children to play with it.
-
The product is intended for private use only, not for commercial purposes.
-
Prolonged use at the highest heat setting can result in skin irritation.
-
The electric over-blanket is not suitable for persons suffering from incontinence.
-
The electric over-blanket is not suitable to be used over or under a water bed.
-
Never use the electric over-blanket if damaged.
-
Examine the appliance frequently for signs of wear or damage. If there are such signs, if the appliance has been misused or does not work, return it to the supplier before switching it on again.
-
Never attempt to repair the electric over-blanket yourself.
-
This appliance must not be used by persons insensitive to heat and other very vulnerable persons who are unable to react to overheating.
-
Children under the age of three are not to use this appliance due to their inability to react to overheating.
-
The switch or control unit must not be allowed to get wet during washing and that during drying the cord must be positioned to ensure that water does not flow into the 21 switch or control.
-
Before storing, allow it to cool down.
-
Do not crease the appliance by placing items on top of
it during storage. -
The appliance is not intended for medical use in hospital.
-
The appliance is not to be used by young children over the age of three unless the controls have been pre-set by a parent or guardian, or unless the child has been adequately instructed on how to operate the controls safely.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
The plastic bag around the blanket is used for hygienic reasons.
-
The appliance is only to be used with the detachable control unit PS7G-H/L that are marked on the appliance.
-
When not in use, please follow the instructions of below paragraph of the manual.
-
Regarding the instructions for appropriate settings of controls for continuous use of the appliance, please refer to the below paragraph of the manual.
Use of the blanket
This blanket is intended to be used as an “over-blanket” and therefore should always be placed on top of an individual, not under them or on the top of a bed sheet. It is not to be used as an “under-blanket”.
-
Make sure the cord set from the blanket is firmly attached to the blanket itself.
-
Insert the plug of the electric blanket (F) into the connector of the electric blanket (G).
-
Insert the plug into the socket (220-240 V AC/50 Hz).
-
Slide the power switch to position “ON”. The appliance is in standby state. The digital display shows “0” for the temperature setting and “0” for the timer setting.
-
Press the button “Temp” to select your desired temperature setting: L (lowest) 1 2 3 4 5 6 7 (from low to high). The timer is set at 9 (hours) by default.
-
Press the button “Time” to select your desired timer setting: 1 2 3 4 5 6 7 8 9 (hours).
-
If needed press the button “High” to set the temperature at the highest level. The
digital display will show “H” and will automatically change to “L” in 1 hour. -
After use, press the power switch to position “OFF” and unplug the appliance from the mains socket.
Take note: The mains socket must be nearby and accessible.
Note
- Please preheat the appliance before use by setting the temperature to “H” for 30-60 minutes. When using it, please select the appropriate temperature setting according to human body’s feeling.
- If you will go to sleep or use the appliance for a long time, please set the temperature to “L” or “1”.
- To remove the switch, lift the locking tab up with your finger and pull the plug directly out. Do not pull the switch cable and do not try and pull the switch plug out without lifting the locking tab as you will damage the socket.
Attention
- If display is “P”, please check whether the coupler (Fig.1) of the product has been connected firmly or not, then restart it. If the fault cannot be removed, it means the internal connection of the product has problems and it needs to ask help from after sales service.
- If display is “E”, it means the product has internal short circuit and has been broken.
Maintenance
Machine washing:
The electric over-blanket can be washed in the washing machine (without the cord!). Set the machine to a Wool or Delicate wash, at a maximum water temperature of 40 degrees, and add a small quantity of detergent.
Take note:
- The electric over-blanket must only be cleaned after the cord has been removed from the blanket.
- The electric over-blanket must not be dry-cleaned.
- The electric over-blanket should never be ironed using a (steam) iron.
- The electric over-blanket must never be dried in a tumble-drier.
- Before washing in the washing machine remove the cord with the switch from the blanket, place the blanket in a string bag and close the neck of the bag.
- Use a small amount of detergent and then select the `Wool or Delicates’ wash programme with a maximum temperature of 40 oC.
- After washing remove the blanket from the string bag.
- Never spin dry the electric over-blanket.
- Gently squeeze as much clean water as possible from the blanket (be careful not to wring the blanket!) and spread it over a drying rack or clothes line to dry.
- Do not use clothes pegs to secure the blanket.
- Let the blanket dry naturally.
- Never use abrasive cleaners, brushes, petrol, paraffin, glass polish or paint thinners for cleaning. Do not wring the blanket. Do not dry the blanket in a dryer. Do not iron the blanket.
- Do not bleach.
- Do not dry the blanket in the sun.
- Do not use an appliance such as a hair dryer to dry it.
Hand washing
- Before cleaning, always remove the cord from the electric over-blanket.
- Immerse the electric over-blanket in (luke)warm water with a mild detergent and leave to soak for 5 minutes. Remove the electric over-blanket from the water and gently squeeze as much water as possible from the blanket (do not wring the blanket). Rinse the electric over-blanket a couple of times in clean water. Gently squeeze as much clean water as possible from the blanket (be careful not to wring the blanket!) and spread it over a drying rack or clothes line to dry.
Caution:
- After washing, do not use the electric over-blanket until it is completely dry.
Storage and maintenance
- Store the electric over-blanket in a cool, dry space.
- Make sure the electric over-blanket is not folded when stored; just roll up the blanket gently.
- Check the product regularly for signs of wear or damage. If there are signs of these, or if the blanket has been misused, please return it to the supplier before reusing. Make sure that you don’t crease the blanket.
- Insulation of the blanket will be damaged if the blanket is dried under the sun, ironed or when mothproofing agents are used. Damage on the insulation material will cause safety problem.
RECYCLING
This product bears the selective sorting symbol for waste electrical and
electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive
2012/19/EU in order to be recycled or dismantled to minimize its impact on the
environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are
potentially dangerous for the environment and human heath due to the presence
of hazardous substances.
QUALITY
Safety and quality is very important to HEMA. We have our own laboratory,
which assesses all equipment in terms of electrical safety and ease of use,
before it is included in our range. HEMA also monitors the product quality in
collaboration with the manufacturer.
SECURITY
This HEMA item may be fitted with a plastic anti-theft strip. You will find
the strip on the bottom of the product. This strip does not influence the
quality or the operation of the product and can be removed without a problem.
FAULTS AND REPAIRS
If this device needs to be repaired, you can hand it in at a HEMA branch after
packing the product securely. Do not try to repair this product yourself. For
repairs that fall within the warranty period, you will need to show a proof of
purchase and the warranty document. Regularly check the power cord for damage.
If there is any damage to the cord set, please return the item to a HEMA
branch for repair. Do not try to replace it yourself. For safety reasons we
recommend that you do not carry out any repairs to an electrical device
yourself.
WARRANTY
The warranty period is 2 years from the date of purchase. Always keep your
receipt in a safe place. It’s handy if you take a picture of the receipt and
save it somewhere. Then you will always have an easy-to-read receipt in your
possession.
WARRANTY CONDITIONS
HEMA quality guarantee
HEMA guarantees that the product you have purchased meets the standards our
customers are entitled to expect in terms of quality and product properties.
These warranty conditions do not affect your statutory or consumer rights and
apply in all countries where there are HEMA branches.
Warranty claims
If you wish to make a warranty claim, please return the product with proof of
purchase to one of our stores. The store will determine whether to replace the
product (with an identical or equivalent product), accept the product for
repair within a reasonable period of time or refund the price of the product.
Invalidation of warranty
The warranty on this article is invalidated if the fault or defect is caused
by:
a) normal wear and tear
b) external damage (for example, damage caused by exposure to sand or moisture
or due to falling of the product, etc.)
c) improper or inappropriate use
d) overdue or incorrect maintenance, including repairs that were not
authorised by HEMA
The above list does not exclude other possible reasons for defects not being
covered by the warranty.
Added confidence when choosing a HEMA product
You may swap or return the product within 30 days after purchase (provided it
is undamaged and you have proof of purchase).
1 November 2019
HEMA BV
PO Box 37110
1030 AC Amsterdam
The Netherlands
These warranty conditions apply without prejudice to the customer’s statutory rights or any other claims by the customer.