Restore Solutions Air Mover with Carpet Clamp Instruction Manual

June 6, 2024
Restore Solutions

Restore Solutions Air Mover with Carpet Clamp
LOGO

Restore Solutions Air Mover with Carpet Clamp

Restore Solutions Air Mover with Carpet Clamp PRO

READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS AIR

MOVER

  •  This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been g- iven supervision or instruction concerning use of the appliance by a person responsible for their safety.
  •  Children should be supervised to ensure that they do not play with the appliance.
  •  If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard
  •  Ensure that the fan is switched off from the supply mains before removing the guard.

WARNING I To reduce the risk of fire, electric shock, or injury:

Restore Solutions Air Mover with Carpet Clamp 2

Restore Solutions Air Mover with Carpet Clamp 3

TROUBLESHOOTING

Problem Cause Solution


Unit will not run.

| 1.  No power to nuit.

2.  Switch not on.

3.  Switch is faulty.

4.  Faulty/broken cord or motor wire

| 1.      Plug unit in. Check circuit breaker.

2.      Place in “ON” position.

3.      Replace switch.

4.      Perform continuity check, using volt/amp meter. Repair/replace faulty broken wire.


Unit runs but air mover makes loud scraping noise.

| 1.  Unit has been severely jolted causing blower wheel to rub against housing.

2.  Unit has been severely jolted causing housing to

deform.

| 1.  Remove motor and replace damaged motor mounts.

2.  Replace blower wheel.


Unit runs but vibrates excessively.

| 1.      Severe jolt has bent motor shaft causing unit to be out of balance.

2.     Air mover blade damaged.

3.      Dirt build up on one side of air mover blade.

| 1.      Remove and replace motor.

2.      Replace blade if necessary.

3.      Clean air mover blade.


Unit runs but blower wheel does not turn.

| 1.  Motor bearings are failing or motor has developed an internal electrical fault.

2.  Intake grill and/or exhaust grill is obstructed.

3.  Excessive duct length.

| 1.      Replace motor.

2.      Remove obstruction.

3.      Reduce duct length to recommended maximum

PRODUCT OVERVIEW

Restore Solutions Air Mover with Carpet Clamp 1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals