Kensington M01542 Caddy with Wireless Charging Instructions
- June 6, 2024
- Kensington
Table of Contents
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio /TV technician for help
Modifications: Modifications not expressly approved by Kensington may void the
user’s authority to operate the device under FCC regulations and must not be
made.
Shielded Cables: In order to meet FCC requirements, all connections to
equipment using a Kensington input device should be made using only the
shielded cables.
**FCC DECLARATION OF CONFORMITY
**
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. As defined in Section 2.909 of the FCC Rules, the responsible party for this device is Kensington Computer Products Group,1500 Fashion Island Blvd, 3rd Floor, San Mateo, CA 94404, USA, 800-535-4242.
**IC STATEMENT
**
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
This class [B) digital apparatus complies with Canadian ICES-003, CAN ICES-3(B)/NMB-3(B).
**CE DECLARATION OF CONFORMITY
**
Kensington declares that this wireless product model is in compliance with the
essential requirements and other relevant provisions of RED (2014/53/EU) and
other applicable EC directives.
For Europe, a copy of the Declaration of Conformity for this product may be
obtained by clicking on the Compliance Documentation’ link at
www.support.kensington.com
The dock meets 2013 ErP Lot6/26 Standby Power Regulations. The power
consumption is less than 2W in standby mode. Standby mode of the dock: the
dock will go into standby mode in one minute after unplugging all the
devices.
INFORMATION FOR EU MEMBER-STATES ONLY
The use of the symbol indicates that this product may not be treated as household waste. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling this product, please contact your local city office, your household waste disposal service, or the shop where you purchased the product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>