BROAN NuTone FG80HBS Heater Fan Light Upgrade Cover Installation Guide
- June 6, 2024
- Broan NuTone
Table of Contents
Heater Fan Light Upgrade Cover
WARNING
Switch power off at the service panel and lock the service disconnecting means
to prevent power from being switched on accidentally.
CAUTION
Always wear safety gloves and glasses.
NOTE: Before installing your upgrade fan cover, plug in the light of
your new fan cover (in the fan outlet) and select color temperature using CCT
switch.
-
Remove the lens by disengaging tabs on both sides of the lens. Your fan cover will look like one of these two options.
https://scnv.io/5miP?qr=1 -
Unscrew acorn nut.
-
Remove reflector by unplugging light plug.
-
Select LED color temperature using the CCT switch (see note above).
-
Extend mounting screw as much as possible.
-
Plug in light plug. (Note: Plug may differ from that pictured.)
-
Orientate LED driver on light cover toward fan side.
-
Secure cover by threading mounting post over the mounting screw. Hand-tighten mounting post until the cover is secure against ceiling surface.
-
Snap in lens.
1103603A
Documents / Resources
|
BROAN NuTone FG80HBS Heater Fan Light Upgrade
Cover
[pdf] Installation Guide
FG80HBS, Heater Fan Light Upgrade Cover
---|---