Changsha Henglei Imp Exp Line Voltage RF RGB Remote User Manual
- June 6, 2024
- Changsha Henglei Imp Exp
Table of Contents
LINE VOLTAGE RF RGB REMOTE USER MANUAL
Specifications
input voltage: | 220-240v ac |
---|---|
max. power: | 400w |
working frequency: | 433.9695MHz |
working temperature: | -20-60°C |
remote control type: | rf wireless |
--- | --- |
wiring type: | common anode |
size: | 104.73.8cm |
weight: | 150g |
Remote Functions
Remote Pairing
- switch off the power
- hold down the “brightness increase” button for 5 seconds
- switch on the power
- led start flashing showing the remote is now fully paired to the controller
- try the remote to see if it’s working
Remote Unpairing
- switch off the power
- hold down the “brightness decrease” button for 5 seconds
- switch on the power
- led start flashing showing the remote is now fully unpaired to the controller
- try the remote to see if it’s working
Safety
- Do not exceed max power 400W, overloading the controller may cause overheating, shorting, and possibly failure of the controller.
- Do not expose the controller or remote to direct or indirect moisture.
- Always observe proper polarity when connecting power and load.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.