Orbegozo CTP 1930 Rechargeable Electric Hair Clipper Instruction Manual
- June 6, 2024
- Orbegozo
Table of Contents
Orbegozo CTP 1930 Rechargeable Electric Hair Clipper
SAFETY INTRODUCTION
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children must never play with the appliance. Cleaning and user maintenance must never be carried out by children without supervision.
- Children should be supervised to ensure that they do not play with the appliance.
- Keep the appliance and the cable cord out of the reach of children less than 8 years old.
- WARNING: In order to ensure your children‘s safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.
- If the supply cord is damaged it must be repaired by the Authorized Service Agent.
- Never pull on the cord when unplugging.
- Do not use the unit with a damaged cord or plug, or if it is not working properly.
- Do not handle the appliance with wet hands.
- Never immerse the appliance in water or any other liquid.
- Make sure the appliance has been unplugged before cleaning.
- This appliance must be installed following the national regulations for electrical installations.
- This appliance is for household use only.
- In case that you need a copy of the instruction manual, you can find it in www.orbegozo.com.
- WARNING: In case of misuse, there is a risk of possible injury.
- Do not reach for an appliance that has fallen into water. Unplug it immediately.
- Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- Do not place or drop into water or other liquid.
- Do not place or store this appliance where it can fall or be pulled into a tub or sink.
- Except when charging, always unplug this appliance from the electrical outlet immediately after using.
- Unplug this appliance before cleaning it.
- Keep the cord away from heated surfaces.
- Do not use where aerosol (spray) products are being used, or where oxygen is being administered.
- Always store this appliance and cord in a moisture-free area.
- Do not use this appliance with a damaged or broken cutter unit, as injury may occur. Always make sure blades are aligned properly.
- Do not wrap the cord around the appliance.
- Do not leave the appliance unattended when it is switched on, as this may be a source of danger.
CHARGE
- Charge your clipper for 16 hours before first use. Make sure the device is switched off while charging the battery. You can charge the clipper by connecting it directly to the charging adapter.
- Turn off the device to charge it.
- It takes 8 to 12 hours for a full charge.
- Once fully charged it can be operational for 30 minutes.
ACCESSORIES
The accessories included are: a hair clipper, an adaptable head for ears and nose, a shaver, a adjustable guide comb, a comb, scissors, a brush and lubricating oil.
CAUTION
ALWAYS TURN OFF THE DEVICE BEFORE ADJUSTING OR CHANGING THE HEAD.
HOW TO USE THE HAIR CLIPPER
- Choose a head that corresponds to your needs.
- Attach the head to the upper part of the razor body: for this, match the bottom of the head with the hole in the accessory holder of the razor, press until you hear a click (see sequence below):
- To remove the head, push the top of the head outward until it pops out.
- Slide the ON/OFF switch to the top to operate the clipper.
- To attach the comb to the beard trimmer attachment, place it on top of the blade and slide it down. This comb can be moved up and down to select the different measurements.
Remove the head Fix the head
Use tips
HAIR:
- Should be dry and free of lotions or other liquids.
- Comb outward with the head 6 and guide-combs to obtain maximum height/length and facing in the same direction. Until you become familiar with hair clipper it is recommended to use the longer measuring guide-combs first.
BEARD/MUSTACHE:
- Use guide-comb with hair clipper for beard.
- Starting under chin, ascend along the cheek in the direction of the ear. Measure in different directions to cut all the isolated hairs.
- To lighten or trim the beard, use a small level so that the hairs do not bend. With the help of the opposite hand, hold the clipper -sharp cutter to the outside- while slowly sliding the appliance along the head.
SHAVER: Use the shaver attachment to clean-up detailed areas. For best results, avoid holding at an angle.
EARS:
- When trimmer inner ears, avoid inserting Grooming System more than 1/4” into ear canal.
- Rotate Grooming System in a circular motion while gently moving in and out of ear canal.
NOSE:
- Insert the hair clipper delicately (accessory 3) and do not put the device more than 1 cm inside the nose.
- Apply a rotating movement to the device during insertion and removal from the nose.
CLEANING, CARE & MAINTENANCE
NOTE: Always clean Grooming System attachments regularly to ensure best performance and a proper operating life.
CLEANING ATTACHMENTS WITH WATER
- Remove attachment.
-
- Rinse ONLY the attachment under warm running water. DO NOT use hot water ad this might cause damage.
CLEANING ATTACHMENTS WITH BRUSH
After first removing attachment, thoroughly brush and blow out hair clippings from cutting system, attachment, and top of power handle.
CLEANING FOIL SHAVER
( DO NOT rinse oil over the foil shaver attachment as this is permanently
lubricated.)
- Remove attachment by pressing security latches on sides of shaver.
- Remove head, shake to remove excess clippings.
- Replace attachment by gently snapping into place.
OILING BLADES & CAUTIONS (Oil provided)
- Rinsing attachments under water requires lubricating the cutting blades 1× monthly. Using only mineral oils (e.g. sewing machine oil), simply spread 1-2 drops lightly over cutters with fingertip. Wipe away all excess.
- Use only mineral oils as these will not evaporate nor slow down speed of cutting blades.
Note: ensure the hair clipper is off while you clean it.
Disposal of old electrical appliances
The European directive 2012/19/UE on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery and recycling of the
materials they contain, and reduce the impact on human health and the
environment.
The crossed out “wheeled bin” symbol on the product reminds you of your
obligation, that when you dispose of the appliance, it must be separately
collected.
Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
CERTIFICATE OF GUARANTEE
We hereby certify that the equipment stated in this Guarantee Card has gone
through strict quality control checks and bears a full Guarantee of 24 months,
which shall come in force from the date of purchase.
During the 24-month guarantee period, the present certificate covers repairs,
workmanship and spare parts for all manufacturing defects, however this
guarantee does not cover those defects that have been caused due to the
following: defects of installation, blows, bad use, breakage of plastic parts
and external causes not related to the equipment. This guarantee does not
include installation and maintenance.
This certificate of guarantee is cancelled on those accessories and components
which are worn due to continuous use. Those which are perishable, such as
plastic components, glass, lamps, filters, rubber or enamelworks which get
worn due to wrongful use or reaction to outside agents such as heating, wáter
or chemical products.
The present certificate of guarantee shall be nullified if the equipment is
handled by any unauthorised personnel.
Customer’s rights:
The seller should be responsible over the customer in the event of lack of
conformity when the product is purchased. It is recognised the right of the
customer to get the product repaired, substituted, decreased its price or the
resolution of the contract.
The present certificate is only valid if it is accompanied by the receipt or
invoice of purchase.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>