Dongguan Xing Yue Electronic XO-9919 Bamboo Wireless Charger User Manual
- June 6, 2024
- Dongguan Xing Yue Electronic
Table of Contents
Dongguan Xing Yue Electronic XO-9919 Bamboo Wireless Charger
Functions:
- Wireless charging surface
- Micro-USB input port
- USB output ports
- LED indicator
What’s included
- 1x Wireless Charging Pad
- 1x USB to Micro USB Cable
- 1x Instruction Manual
Tech Specifications
- Micro-USB Input: 5V/2A Max
- USB Outputs: 5V/1.5A total (max)
- Wireless Output: 5W
Instructions
Wireless Charging Mobile phones and other electronic devices:
- Connect the provided micro-USB to USB cable to the micro-USB input port(2), then connect the USB end of the cable to a power source.
- LED indicator(4) will flash BLUE & RED 3 times, then glow RED to indicate the wireless charger is in standby mode and ready to begin charging.
- Place the wireless charging supported mobile device on the wireless charging surface(1), LED will glow BLUE when device is charging.
- Phone will begin to charge automatically.
- Once fully charged remove the device.
Note: When wireless charging. if the LED indicator flashes RED and BLUE alternately, the device Is ether NOTa wireless charging device or there is an object between the the device and charging surface interfering with the charging process.
Charging mobile phones and other electronic devices:
- Connect the charging cable to your mobile phone/device using the appropriate connector. Connect the USB part of the cable into either USB Output(3) ports.
- LED Indicator will lluminate RED when charging a device. Remove the cable from your mobile device when it is fully charged.
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject To the following two conditions:
- This device may not cause harmful interference, and
- (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 and part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and candidate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected. This device complies with Part 18 of the FCC Rules.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>