Dongguan Xing Yue Electronic EB07 Wireless Earbuds User Guide

Dongguan Xing Yue Electronic EB07 Wireless Earbuds User Guide

How to use the earbuds

Bluetooth pairing

Remove earbuds from case, prompt a voice “Power on”, then a beep to indicate both earbuds sync to each other, now main earbud LED flash Red& Blue, secondary earbud flash Blue slowly. Turn on the Bluetooth function on mobile device, Select “TWS Earbuds” pairing name. After connect Bluetooth, prompt a voice “connected”. now both earbuds LEDs flash blue slowly. Disconnect Bluetooth will prompt a voice “Disconnected”. Long press earbuds button about 5 seconds to power off earbuds and hear a voice prompt “Power off”. If disconnect Bluetooth after 5 mins, the earbuds will auto shut off.

Playing Music

• Play/Pause/Answer call/Hang up – One tap/touch/click on button
• Next track – Double tap/touch/click on button, Right Earbuds
• Previous track – Double tap/touch/click on button, Left Earbud
• Activate voice assistant – Long press on button 2 seconds, both earbuds
• Reject call – Long press on button 2 seconds when calling.
• long press the button 5 seconds to turn off , long press 3 seconds to turn on.

Charging the earbuds

When case has power, put one earbud into case this earbud will auto start charging until earbuds fully charged, the other earbud will remains on. Put both earbuds into case, earbuds will turn off and start auto charging until earbuds fully charged.

Earbuds playback time at max volume: about 4hours.

Charging case charge the earbuds: Solid Red LED on earbuds when charging and solid Blue on case, LEDs on both earbuds and on case all turn off when earbuds are fully charged.

FCC Warning

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>